Tender For Infra Structure 1 Works Under Itphds Fund (Vp) 2024-25- Vadamadurai Block - Tn-05-01, Dindigul-Tamil Nadu

Tender For Infra Structure 1 Works Under Itphds Fund (Vp) 2024-25- Vadamadurai Block - Tn-05-01; 1 1. Construction ofCommunity Hallat Kulathur H/O KulathurEstimate Amount Rs.45.00 Lakhs 2 Earth work excavation for foundation in all soils and sub-soils and to full depth as may be directed except in rock requiring blasting inclusive of shoring shuttering, bailing out water wherever necessary and depositing the surplus earth within the compound in places shown by thedepartmental officers with an initial lead of 10 mts and initial lift of 2 mts. and clearing and levelling the site, etc., complete complying with standard specification. 3 Supplying and filling in foundation, basement, etc with filling sand in layers of not more than 15 cm thick well watered, rammed and consolidated etc. complete complying with standard specification and as directed by the departmental officers. 4 Cement Concrete 1:4:8 (One Cement, Four sand and Ten hard broken stone jelly) using 40 mm gauge hard broken granite stone jelly for foundationincluding dewatering wherever necessary and laid in layers of not more than 15 cm thick well rammed, consolidated and curing etc. complete complying with standard specification 5 Brick work in Cement Mortar1:5 (one cement and five sand) using best quality of country bricks of size 8-3/4 x 4-1/4 x 2-1/4for foundation and basement including curing, etc., complete complying with standard specifiction. (Below Basement) 6 Brick work in Cement Mortar1:5 (one cement and five sand) using best quality of country bricks of size 8-3/4 x 4-1/4 x 2-1/4for foundation and basement including curing, etc., complete complying with standard specifiction.(Above Basement) 7 Supplying and erecting centering for sides and soffits including necessary supports and strutting upto 3.29 M height for plane surfaces as detailed below in all floors with all cross bracings using Mild Steel sheets of size 90 x 60 cm and 10 BG stiffened with welded Mild Steel angle of size 25mm x 25mm x 3 mm for boarding laid over silver oak joists of size 10cm x 6.50 cm spaced at abote 90 cm centre to centre and supported by casurina props of 10cm to 13 cm dia spaced at not more than 75 cm centre to centre etc. complete complying with the standard specificaiton 8 Below GL 9 Above GL 10 Supplying, fabricating and placing in position Mild Steel / Ribbed Tor Steel grills for all RCC works as per design given including cost of steel and G.I. binding wire in all floors etc. complete complying with standard specification. 11 RCC 1 :1.5 : 3 mix using 20mm ISS HBG metal including cost and conveyance of all materials but excluding centering charges including labour charges for mixing laying concrete etc., complete (below basement) 12 RCC 1 :1.5 : 3 mix using 20mm ISS HBG metal including cost and conveyance of all materials but excluding centering charges including labour charges for mixing laying concrete etc., complete (Above basement) 13 Supply ing and appl ying of two coats of p utty of 3 mm thick over the exposed RCC surfaceofceilingincludingfinishingthejointssmoothywithgrindingmachine andthesurfaceshallbethoroughlycleanedoutofdustandscrubbing.The Surfaceshallthen beallowedto dryforatleast48hours. Tt shallthen be sand papered(waterproofabrasivesheet)togiveasmoothandevens urface. Any uneven nessshallbe madegoodbyapplying1stcoatof puttymixedwithwater ontheentiresurfaceincludingfillinguptheundulationsandapplying2ndcoat 1 ofputtyalter6hoursof1stcoatofputtyandthensandpapering(waterproof a bra sive s heet)th e samearte ritisdryandfinishingthc surfa cesm oot hIy, «tc., 14 Plastering with Cement Mortar 1:5 (One cement and Five sand), 12mm thick in all floors including curing etc. complete complying with standard specification and as directed by the departmental officers. 15 Plastering in CM 1:4 20mm thick including cost and conveyance of all materials and labour charges etc. complete 16 Plain Cement Concrete 1:2:4 mix using 20mm ISS HBG metal including cost and conveyance of all materials and labour charges etc. complete 17 Paving Floor with Vertified tiles of size 600x600x8mm of any colour, laid in C.M 1:3 mix 20 mm thick & pointing with colour cement using 0.40kg per sq.m including cost & conveyance of all materials to site and all labour charges etc.complete 18 Paving the floor with best approved quality fine polished shahabad stone slabs of size 600 x 600 of 18 / 20mm with machine cut edges and matching marble slab not less than 100mm width other than Adanga Marbles as border laid over a cement mortar bed of 20mm thick using cement mortar 1:3 (One cement and three sand) fixing the slabs in true right angles with minimum possible width of joints and pointing the joints with white cement mixed with mathcing colouring pigments and polishing with floor polisher to a high degree of finish etc., The kota stone slabs and other materials to be used shall be got approved by the Executive Engineer concerned before use on work, etc., complete as per standard speicification 19 Paving the floor with best approved quality fine polished Kota stone slabs of size 600 x 600 of 18 / 20mm with machine cut edges and matching marble slab not less than 100mm width other than Adanga Marbles as border laid over a cement mortar bed of 20mm thick using cement mortar 1:3 (One cement and three M.Sand) fixing the slabs in true right angles with minimum possible width of joints and pointing the joints with white cement mixed with mathcing colouring pigments and polishing with floor polisher to a high degree of finish etc., The kota stone slabs and other materials to be used shall be got approved by the Executive Engineer concerned before use on work, etc., complete as per standard speicification. 20 Paving the floor with scrach proof ceramic tiles of any colour and any size laid in CM 1:2, 20 mm thickand pointing with white cement using 0.4kg/Sq m mixed with colouring pigments to suit colour of the tiles including finishing tec., complete 21 Dadooring walls with glazed tiles of size 0.15 x 0.15 set with CM 1:3, 10 mm thick etc., complete 22 Brick jelly Lime concrete by using 20 mm brick jelly with lime in the ratio of 32 : 12.5 including cost conveyance of all materials and labour charges for mixing laying compacting well beaten with wooden batens etc complete 23 Finishing the top of roof with one course of machine pressed tiles of size 20cmx20cmx20 mm of approved quality laid in cement mortar 1:3 mix to 12mm thick mixed with water proofing compound confirming to ISS by 2% weightof cement used and the joint pointed 24 Supply of the following steel doors, windows and ventilators to Office, etc. complete 25 Main Door - D 26 Door - D1 27 Door - D2 pvc door 28 Window - W 29 Window - W1 30 Ventilator 31 Ventilator 32 Supply of the following PVC pipes and PVC specials etc. completeFor Seewage Line and Rainwater Down Fall Pipewith necessary bend ,shoes and clamp and labour charges etc complete 33 110mm PVC pipe 34 Supply of Manhole cover60cm x 60 cm 2 Nos. 35 Painting Two Coats of OIL Bound Distemberof approved colour over one Primer Coat including cost of Paint and labour charges etc complete 36 Painting Two Coats with exterior emulsion of approved colour over one Primer coat including cost of Paint and labour charges etc complete 37 Painting two coats with ready mixed paint including cost and conveyance charges etc. 38 FixingCharges for Steel Door in Position etc complete 39 Supply and Fixing of Cudapah Slab of 25mm/40mm thick including cost and conveyance of all materials and labour charges etc complete 40 FixingCharges for Steel Windows in Position etc complete 41 Supplying & Fixing in positionof Indian type Water closet 580x440mm ofapproved quality 42 EWC 43 Provision for Electrification 44 Wiring with 2 x 1.50 sqm ( 22/0.3) PVC insulated unsheathed single core Copper Conductor of 1100 v Grade in suitable PVC Rigid Pipe on wall and ceiling with PVC accesseries with TW box 150 mm x 100 mm x 113 mmfor 5A3 Pin non inter locking cs plug with painting of suitable colour with contionues earth wire connection of 14 SWG TC Wire for PVC PLUG PointS D N o 36 45 Wiring with 2 x 1.50 sqm ( 22/0.3) PVC insulated unsheathed single core Copper Conductor of 1100 v Grade in suitable PVC Rigid Pipe on wall and ceiling with PVC accesseries with TW Switch box with 5 A F . T . Switch with painting of suitable colour for OPEN PVC Light Point and Fan Point ( For Eloctronic Regulator ) S D N o 25 46 Supply and Fixing of 18 WCFL in the existing light point SD 83 47 Supply and fixing of 32 A DPIC Switch of 500 v with F & N ( Side Handle ) on suitable T W Box with PWD Earthing ( S D N o 144 ) 48 Supply and Run of 2 of 6 sqmm ( 84 / 0.3 ) PVC insulated single core unsheathed Copper Conductor of 1100 v Grade on 7 / 20 G I Bearer wire for Service Connection Mains ( S DNo 66 ) 49 Supply and Run of 2 of 6 sqmm ( 84 / 0.3 ) PVC insulated single core unsheathed Copper Conductor of 1100 v Grade in25 mm dia G I suitable pipe b class suitably bended both ends with necessery angle iron upright and end support For Mains ( S D N o 71 ) 50 Supply and Fixing of Water TIGHT Bulk Head fitting with Guard for incandescent lamp with 60 w Bulb S D No 84 51 Supply and fixing of 1200 mm ( 48 ) A C Ceiling Fan complete with stepped eloctronic 300 w regulator with 1.00 meter down Rod on the existing clamp S D N o 110 52 Provision for Metre Board 53 Provision for EB Deposit charges 54 Provision for Lock and Key 55 Provision for Name Board 56 GST Amount for providing Service to Government Contract Works for the above Construction Works. { GST Amount is the Total GST Amount for total overall quoted amount above this row in column BB for all works in this package}

Refer document

INR 45000.0 /-

Refer document