As Per Tender Documents, Equipment For Power System Lab - ( 1 ) Input 3 Phase Dol Starter Panel Should Consists Of : A ) 4 Pole Mcb Of 415 V / 4A, B ) Dol 9A Contactor With 230V / 50 Hz / 11Va Coil, C ) Bimetallic Thermal O / L Relay With Range 2.5A -6A ( 2 ) Fwd-Off-Rev, Switch Panel Should Consists Of : A ) Fwd / Rev, 3 Pole 3 Way Switch With Center Off, 6A / 440V. ( 3 ) 3 Phase Bidirectional Power Cum Energy Meter Panel Should Consists Of : A ) Bidirectional Multifunction, B ) 3 Phase 3 / 4 Wire, 415Vac, Ct Input 5A, C ) Lcd / Led Display, Aux. Supply 230V, 45-65Hz, 5W, D ) V, I, Hz, Pf, Kva, Kw, Kwh, E ) Modbus Rtu Rs 485 Connections. 4 ) Var Compensation Panel ( Dual Panel ) Should Consists Of : A ) Var Compensating Capacitors Of 2, 4, 6, 8, 10 & 15Μf Each Of 3 Nos. With 3 Pole 7 Way Switch For Selection. 5 ) Transmission Line Panel - Table Top Panel Should Consisting Of : A ) Simulated Model For Transmission Line ( 250Kms ) Using R ( 10 Ohm / 600W ) , L ( 0.15H / 5A ) & C ( 2.2Uf / 630V ) 6 No. Each Component. B ) Simulated Model For Medium / Long Length Transmission Line For Pi Model. C ) Simulated Model For Medium / Long Length Transmission Line For T Model. D ) Optionally 2 Transmission Line Panels Supplied To Simulate Up To 500Kms Length. 6 ) Rlc Load Panel - Table Top Panel Should Consisting Of A ) 3 Nos. Of 600W Resistors With Switch Selectable 7 Nos. Of Taps At 100, 112, 125, 150, 175, 200 & 225, B ) 3 Nos. Of Inductor 1.5H / 1A With Switch Selectable 6 Nos. Of Taps At 0.3, 0.6, 0.75, 0.9, 1.2 & 1.5H, C ) Capacitors 440Vac Rating ( 3 Nos. One Per Phase ) With Switch Selectable 7 Nos. Of Value Of 2, 5, 10, 15, 20, 30 & 50Μf. 7 ) 3 Phase Dimmer / Variac Panel – Table Top Panel Should Consisting Of A ) 3 Phase Dimmer I / P : 415Vac, 50Hz, Op : 0-470Vac, 6A, 3 Phase. 2 ) Electrical Power Generation Setup 3 ) Biased Differential Relay Trainer 4 ) Distance Protection Relay Trainer 5 ) Feeder Protection Relay Trainer6 ) Over / Under Voltage Relay Trainer