Annual Rate For Various Work And Civil Work At Various Work Including Materials And Labour Charges Of Vapi Vapi Municipal Corporation Area (Annual Rate 2025-2026), Vapi-Gujarat

Annual Rate For Various Work And Civil Work At Various Work Including Materials And Labour Charges Of Vapi Vapi Municipal Corporation Area (Annual Rate 2025-2026)--1. Excavation for foundation upto 1.5 m depth including sorting out and stacking of useful materials and disposing off the excavated stuff upto 50 Meter lead.(C) Hard Murrum (a) Lift upto 1.5 meter. (S.O.R.2023-24, item Code- 04003C, item No. 00,Page No.44) 1.00 / Cu.Mt. 2. Construction of granular sub-base by providing coarse graded machine crushed B.T. material satisfying MOST specification of grading I (B.T. stone aggregate 53 mm to 26.5 mm 35 %, 26.5 to 4.75 mm - 45 % and 2.36 mm below - 20 % )including spreading in uniform layer with motor grader on prepared surface, mixing by mix in place method with rotavator at OMC and compacting with vibratory roller to achieve the desired density etc. complete. ( As Per R.A.) 1.00 / Cu.Mt. 2. Boring holes 3.5 m deep in ordinary soil (for cast in situ piles) and getting out the soil and disposal of the surplus excavated soil as directed within a lead of 50 Meter for following diameter of pipes. 300 mm Dia 1.00 / Nos 3. (1)Brick work using common burnt clay building brick having crushing strength not less than 35 kg/sqcm in foundation and plinth in (i)cement mortar 1:6 (1 cement: 6 fine sand) 1.00 / Cu.Mt (ii)cement mortar 1:8 (1 cement : 8 fine sand) 1.00 / Cu.Mt (2)Uncoursed rubble masonary with hard stone of approved quality in foundation and plinth in cement mortar 1:6 (1 cement : 6 coarse sand) including leveling up etc. complete 1.00 / Cu.Mt 4. Pointing on coursed stone masonry with cement mortar 1:2 (1 cement : 2 sand) Flush pointing 1.00 / Sq.Mt 5. Providing 15 mm thick cement plaster in single coat on brick/concrete wall fir interior plastering up to floor two level finished even and smooth in cement mortar 1:4 (1 cement :4 sand) 1.00 / Sq.Mt 6. Providing 20 mm thick Sand faced cement plaster on wall up to height 10metres above ground level consisting of 12mm thick backing coat of C.M 1:3 (1 cement : 3 sand) 8mm thick finishing coat of C.M 1:1(1 cement : 1 sand)etc. complete. 1.00 / Sq.Mt 7. Providing and laying Cement Concrete 1:2:4 (1 Cement :2 coarse sand : 4 graded stone aggregate 20 mm nominal size) and curing complete including cost of form work but excluding cost of reinforcement for reinforced cement concrete work in foundations and plinth and mass concrete and for slab work. 1.00 / Cu.Mt 8. Providing and laying in position Ready Mixed Concrete for reinforced cement concrete work , using cement content as per approved Design Mix manufactured in fully automatic batching plant and transported to site of work in transit mixer for a lead up to 10 kms having continuous agitated mixer, manufactured as per mix design of specified grade for reinforced cement concrete work including pumping of R.M.C. from transit mixer to site of laying, including the cost of centering shuttering finishing and reinforcement including cost of admixtures in recommended proportions as per IS: 9103 to accelerate/ retard setting of concrete, improve workability without impairing strength and durability Without Fly Ash (Min cement level as per latest IS 456 shall be maintained) (Cement level 400 kg ) as per direction of the Engineer - in - charge. Concrete grade M: 150 1.00 / Cu.Mt Concrete grade M: 200 9. Providing and laying in position Ready Mixed M-250 grade concrete for reinforced cement conctere work , using cement content as per approved Design Mix manufactured in fully automatic batching plant and transported to site of work in transit mixer for a lead up to 10 kms having continuous agitated mixer, manufactured as per mix design of specified grade for reinforced cement concrete work including pumping of R.M.C. from transit mixer to site of laying, Including the cost of centering shuttering finishing Smooth in trimix with surface vibrator & vacuum pump & fan Groove Cutting & filling bitumen fillers as Directed by engineer in charge and admixtures in recommended proportions as per IS: 9103 to accelerate/ retard setting of concrete, improve workability without impairing strength and durability as per direction of the Engineer - in - charge. Without Fly Ash (Min cement level as per latest IS 456 shall be maintained) (Cement level 450 kg ) Concrete grade M: 150 1.00 / Cu.Mt Concrete grade M: 200 1.00 / Cu.Mt Concrete grade M: 250 1.00 / Cu.Mt Concrete grade M: 300 1.00 / Cu.Mt 10. Providing Formwork of ordinary timber plankings so as to give a rough finished including centering, shuttering, struting and propping etc. height of propping and centering below supporting floor to ceiling not exceeding 4.0 Mt. and removal of the same for cast in situ reinforced concrete and plain concrete work.(A) Foundation footings Bases Of Columns Etc. Mass Concrete 1.00 / Sq.Mt 11. (i)Providing TMT FE-415 bar reinforcement for R.C.C. work including bending and placing in Position complete upto floor two level. 1.00 / Kg. (ii)Providing TMT FE-500 bar reinforcement for R.C.C. work including bending and placing in Position complete upto floor two level. 1.00 / Kg. 12. Providing and laying Cement Concrete and curing complete including cost of form work in Foundation and plinth in at any level (i) Cement Mortar 1:1.5:3 (1 Cement :1.5 Coarse sand : 3 graded stone aggregate 20 mm nominal size) 1.00 / Cu.Mt (ii) Cement Mortar 1:2:4 (1 Cement :2 Coarse sand : 4 graded stone aggregate 20 mm nominal size) 1.00 / Cu.Mt (iii) Cement Mortar 1:3:6 (1 Cement :3 Coarse sand : 6 hand broken stone aggregate 40 mm nominal size) 1.00 / Cu.Mt (iv) Cement Mortar 1:4:8 (1 Cement :4 coarse sand :8 hand broken stone aggregate 40 mm nominal size)

Refer document

Refer document

Refer document