Annual Rate Contract Of Various Works At Various Places In East Side Of Suratgarh Road, Sri Ganganagar - Dismantling old plaster or skirting, raking out jouts and cleaning the surface for plaster including disposal of rubbish to the dumping ground within 50 meter lead. Demohshing brick work manually by mechanical means including stacking of serviceable material and disposal of unserviceable material within 50 metres lead as per direction of Engineer-in-charge Earth work in excavation by mechanical means (Hydraulic Excavator manual means in foundation trenches or drains (not exceeding 1.5 m in width or 10 sum on plan) including dressing of sides and ramming of bottoms, lift upto 1.5 m, including taking out the excavated soil and depositing and refilling of jhiri with watering & ramming and disposal of surplus excavated soil as directed with in a lead of 50 meter. All kinds of soils Providing and laying in position cement concrete including curing, compaction etc. complete in specified grade excluding the cost of centering and shuttering All work up to plinth level 1:4.8 (1 cement 4 coarse sand 8 graded stone aggregate 40 mm nominal size). Brick work with common burnt clay F.P.S.(Non Modular) bricks of class designation 7.5 in foundation and plinth with Cement mortar 1:6 (1 cement: 6 coarse sand) Centering and Shuttering with plywood or steel sheets including strutting, propping bracing both ways and removal of formwork for foundation, footings, strap beam, raft, bases of columns etc Centering & shuttering with plywood or steel sheets including strutting, propping bracing both ways with steel props and removal of formwork for upto floor five level for Suspended floors, roofs, landings, staircases, balconies, girders, cantilevers, bands, coping bed plates, anchor blocks, sills, chhajjas, lintel, beam, plinth beam etc. Brick work with common burnt clay F.P.S.(Non Modular) bricks of class designation 7.5 in superstructure above plinth level upto floor five level in all shapes and sizes in Cement mortar (16) Providing and laying in position specified grade of cement concrete for all RCC structural elements upto plinth level including curing, compaction, finishing with rendering in cement sand mortar 13 (1 cement 3 coarse sand and making good the joints and cost of plastizers( if required) excluding the cost of centering, shuttering and reinforcement M20 grade Nominal Mix/ Design Mix Providing and laying in position specified grade of cement concrete for RCC structural elements upto floor five level including curing, compaction, finishing with rendering in cement sand mortar 13 (1 cement 3 coarse sund) and making good the joints and cost of plastizers if required) excluding the cost of centering, shuttering and reinforcement for Beams, suspended floors, roofs, griders having slopes up to 15, landings, balconies, shelves, chajjas, lintels, bands, plain windows sills, staircases and spiral staircases etc. M20 grade Nominal Mix/ Design Mix Descriptions of item. 1.0 Providing and fabricating remforcement for RCC work including straightening, cutting, bending, placing im position and binding (including cost of binding ware) all complete tip to floor five level Thermo-mechanically Treated bars (Conforming of relevent is code) Providing and fixing pressed steel door frames confirming to IS 4351 manufactured from commercial mild steel sheet of 125 mm thickness including hinges jamb, lock jamh, bead and if required angle threshold of mild steel angle of section 50x25mm, or base thes of 1 2.5mm pressed mild steel welded or ngadly fixed together by mechanical means, adjustable lugs with split end tail to each jamb including steel butt hinges 2.5mm thick with mortar guards, lock strike-plate and shock absorbers as specified and applying a coat of approved steel primer after pre-treatment of the surface including filling with CC 12.4(M15 grade) complete as directed by Engineer-in-charge Profile E Providing and fixing steel glazed doors windows and ventilator shutters of standard rolled steel section joints mitred and welded with steel lugs 13x3mm, 10cm long embedded in cement concrete block 15x10x10cm. of 1:3:6 (1cement: 3 coarse sand 6 graded stone aggregate 20mm nominal size) or with wooden plugs and screws or rawl plugs and screws with fixing clips or with bolts and nuts as required including providing and fixing of plain glass panes 4mm thick with cooper glazing clips and special metal sash putty of approved make or metal beading with screws complete including priming coat of approval steel primer, excluding the cost of metal beading and other fitting except necessary hinges of pivots steel handles peg stay etc. as required: Windows fixed S&f fixed wire gauge of stainless steel of 14 mesh x 24 gauge to the aluminium window by Aluminium beading 20x3mm with surtable screws not exceeding 150mm distance at all heights with all lead and lift with scafolding. Providing and fixing Square bars or other flat welded to window, ventilatiors etc. Providing and fixing M.S. sheet Imm thick single leaf door shutter in angle iron frame 35x35x5mm suitabilly diagonally braced with 25x3mm flat iron above and below lock rail of size Six5mm beading extra including all fittings, as per direction of Engg incharge but excluding cost of chowkhats, including two coats of anit-corrosive red oxide primer paint Repair to brick masonary in cement sand mortar 16 with new brick 18 Repairs to plaster of thickness 12mm to 20mm in patches of area 2.5 sq metres and under including cutting the patch in proper shape, raking out joints and preparing and plastering the surface of the walls complete including disposal of rubbish to the dumping ground within 50 m lead With cement mortar 14 1 cement 4 coarse sand) 19 Plaster on new surface on walls in cement sand mortar 16 including racking of joint etc complete fine finish 12 mm thick 20 Kota stone slabs 20 mm thick in risers of steps, skirting, dado and pillars laid on 12 mm (average) thack cement mortar 13 (1 cement 3 coarse sand) and jointed with grey cement slurry mixed with pigment to match the shade of the slabs, including rubbing and polishing complete For area of each slab from 2001 to 5000 Sqcm 21 Providing and applying plaster of paris putty of 2 min thickness over plastered surface to prepare the surface even and smooth complete 22 Providing and applying white cement based putty over plastered surface to prepare the surface even and smooth complete Sr. No. Descriptions of item. )س( W 23 Distempering with oil bound washable distemper of approved brand and manufacture to give an even shade including all scaffolding New work (two or more coats) over and meluding serapping and priming coat with cement primer internal plaster 24 Painting with synthentic enamel pant of approved brand and manufacture to give an even shade Two or more coats on New Work 25 Grading roof for water proofing treatment with water proffing compound Cement concrete 1:2:4 (1 cement 2 coarse sand: 4 graded stone aggregate 20 min nominal size) Providing and fixing 20 mm thick precast terrazo tiles of approved make, with marble chips of size upto 6mm laid over roof with neat cement slurry mixed with pigment to match the shade of the tiles, including cutting grinding rubbing with machine complete on 20 mm thick bed of cement sand mortar 14 Providing and laying in position cement concrete including curing compaction etc. complete in specified grade excluding the cost of centering and shuttering 1: 1.5: 3 M 20 Grade nominal mix (1 cement, 1.5 coarse sand, 3 graded stone aggregate 20 mm nominal size ). B-3, 3.1.1, BSR) Steel work in built up tubular trusses including cutting, hoisting (height upto 10 m)fixing in position and applying a priming coat of approved steel primer, welded and bolted including special shaped washers etc. complete. Hot finished welded type tubes Providing and fixing steel gate, grating, and grills made of angles, tees, square bars, flats, or black pipe with holdfast and fittings complete as per design and drawing including cutting welding and fabrication with priming coat of red oxide Extra if square rectangular hollow tubelar sections are used or grill made by flats only Construction of embankment with approved material obtained from borrow pit with all lifts and leads, transporting to site, spreading, grading to required slope and compacting by vibratory roller 8-10 tonne to meet requirement of table 300-2 including cost of compensation for earth taken from private land complete as per MoRT&H specification clause 305. (Lead taken upto 5 km) Providing and laying factory made chamfered edge plastic coated designer cement concrete paver blocks of required strength thickness and size/shape, made by table vibratory method to attain superior smooth finish using PU or equivalent moulds, laid in required Grey/yekw/Red or any other colur and pattern over 50mm thick compacted bed of Coarse sand, compacting and proper embedding/laying of inter locking paver blicks into the sand bedding layer through vibratory compaction by using plater vibrator, giling the joints with fine sand and cutting of paver blocks as per required seze and pattern firushing and sweeping extra snad in footpath, parks Lawns, drive ways or light traffic parking ete all complete as per manufacturers sepecifications and direction of Engineer-in-charge 80 mm thick CC interlocking paver of M 30 grade with aproved colour design and pattern Descriptions of item Providing and laying at or near ground level factory made kerh stone of M-25 grade cement in position to the required line, level and curvature jointed with cement mortar 1:3 (1 cement: 3 coarse sand) including making joints with without grooves (thickness of joints except at sharp curve shall not to more than 5mm) including making drainage opening wherever required complete including painting ete, as per direction of Engineer-in-charge (length of finished kerb edging shall be measured for payment) (Precast CC kerb stone shall be approved by Engineerm- charge) Construction of granular sub-base by providing coarse graded material, spreading in uniform layers with motor grader on prepared surface, mixing by mix in place method with rotavator at OMC, and compacting with vibratory roller to achieve the desired density, complete as per clause 401. By mechanical means with all lead Grading III Material Providing, laying, spreading and compacting stone aggregate having physical requirement as per table 400-8 and of specific sizes as per table 400-9 to Water Bound Macadam specification including spreading in uniform thickness, hand packing rolling with vibratory roller in stages to proper grade and camber, applying and brooming requisite type of screening and binding materials to fill up the interstices of coarse aggregates watering (with water browser) and rolling, making necessary earthen bund to protect edges, lighting, guarding. barricading and maintenance of diversion etc. [MoRTH specification Clause 404 & 112Using Screening Crushable type such as Moorum or Gravel Providing and laying of hot applied thermoplastic compound 2.5 mm thick including reflectorising glass beads @ 250 gms per sqni area, thickness of 2.5 mm is exclusive of surface applied glass beads as per IRC:35 The finished surface to be level, uniform and free from streaks and holes.). Cement concrete flooring 1:2:4 (1 cement: 2 coarse sand: 4 graded stone aggregate) finished with a floating coat of neat cement including cement slurry, making of lines or groove etc complete but excluding the cost of nosing of steps etc. complete 40mm thick with 20mm thick nominal size aggregate P&F 1st qualityVitrified Porcelain Polished tiles on floor, skirting and steps etc.in different sizes (thickness to be specified by manufactuer) with water absortion less than 0.08% and conforming to IS 15622 of approved make in all colour and shade, laid with 20 mm thick CM 1:4 including grounting the joints with white cernent and matching pigment elc complete 600 x600 mm P&F Ist quality Vitrified Porcelain Polished tiles on floor, skirting and steps ete in different sizes (thickness to be specified by manufactuer) with water absortion less than 0.08% and conforming to IS 15622 of approved make in all colour and shade, laid with 20 mm thick CM 14 including grounting the joints with white cement and matching pigment etc complete 450x450 mm Providing and fixing Ist quality standard white, grey, ivory, fume red brown, light green, light blue and other light shades glazed tiles confirming to IS 13753 & 18 15622 of size 200mm x 300mm in walls, floors, steps, pillars ete laid on a bed of neat cement slurry finished with flush pointing in the white cement mixed with pigment to match the shade of the tile complete (excluding the cost of cement plaster on walls and pillar) Descriptions of item P&F WVC wash baun (1st quality, 15 2556 Mark) of approved make with C1 Brackets duly pamted, 1 NO 15 mm CP Pillar cock (15 8034 mark) & 12 mm CP brass waste coupling of approved make, 25 mm G1 Waste pipe complete including cutting & making good the wall Size 550mm x 400mm P&I Ist quality WVC Urinal (IS 2556 mark) with 25mm dia G1 waste pipe, dome waste couplings, concealed won brackets or screws etc complete Flat Hack (small) size 45355265mm P&F Marble Urinal Partition slab both sides polished of approved design cut from marble size 900x600mm Makrana II quality marble having light spots Providing & Fixing Premium Quality white glazed vitreous china Sanitary Wares (18 2556 Mark) of approved make as per direction of Engineer-in-charge including cutting and making good the wall and floor Universal (anglo-Indian type) with Por S trap Double Syphonic European WC with mounted W.V.C. flushing cistern of 10 litre capacity complete with all necessary internal fittings with Hydraulic seat cover. P & F Indian type white glazed vitreous china 1st quality W.C. oissa pan (15 2556 Mark) with 100 mm vitreous china Por S trap including cutting and making good the wall and floor: Size 530x410mm Providing and fixing Chlorinated Polyvinyl Chloride (CPVC) pipes, having thermal stability for hot & cold water supply including all CPVC plain & brass threaded fittings i/c fixing the pipe with clamps at 1.00 m spacing. This includes jointing of pipes & fittings with one step CPVC solvent cement and testing of joints complete as per direction of Engineer in Charge (Internal work Exposed on wall) 15mm PAF Bib cock (IS 8931 Mark) Superior quality of approved make Brass 400gm 15mm nominal bore P&I Full-way Valve (15.778 Mark) or wheel valve of approved make Gun metal 25 mm nominal bore PAF PVC storage tank confirming to (15 12701 indicating the BIS license No) of approved make with cover, 25mm dia 1 M long G1 Over-flow pipe & 25 cm long wash out pipe with plug & socket, including making connection etc, complete of approved design 1000 liters capaслу P&Frigid PVC pipe (15 4985 mark) class 11 (4 Kg Per Cm 2 approved quality/make including jointing the pipe with solvent cement rubber ring and lularicant 110man dia Construction of soakage well in all types of suid of approved drawing sup 90cm purtion in 450mm thick masonry with CM 1.6. 80mm thick stone slali covering, jointing of slab as CM 13. Ralthal, Kharanja 40mm dack M-15 grade CC Roamg. earth work etc complete incl disposal of surplus earth within alead of 50mir Inner dia 90cm & 10 to 12 mtt deep etc.
