}

Tender For Provision Of Ug Sump For Sewage Line With Connected Items In Ch (Wc) At Chandimandir, chandimandir-Haryana

Military Engineer Services has published Tender For Provision Of Ug Sump For Sewage Line With Connected Items In Ch (Wc) At Chandimandir. Submission Date for this Tender is 19-04-2025. Sump Tenders in chandimandir Haryana. Bidders can get complete Tender details and download the document.




Tender Notice

48475407
Tender For Provision Of Ug Sump For Sewage Line With Connected Items In Ch (Wc) At Chandimandir
Open Tender
NCB
Haryana
Chandimandir
19-04-2025

Tender Documents

Tender Details

Tender For Provision Of Ug Sump For Sewage Line With Connected Items In Ch (Wc) At Chandimandir; 1 Schedule A Section-I (Building works) 2 Total Amount of Sch A Sec-I (Building works) 3 Schedule A Section-II (Earth works) 4 Total Amount of Sch A Sec-II (Earth works) 5 Schedule A Section-III (Sewage Disposal Works) 6 Total Amount of Sch A Sec-III (Sewage Disposal Works) 7 Schedule A Section-IV (External Electrification Works) 8 Total Amount of Sch A Sec-IV (External Electrification Works) 9 Schedule A Section-V (Misc items of Works)Note:- This schedule is not pre-priced by MES and the pre-priced rate indicated as Rs 0.00 under Col. 5 signifies this fact only 10 Misc items of Works 11 Old size sub class B bricks, laid in trenches as cable cover complete all as specified and directed by Engineer-in-Charge. 12 Supplying, laying, jointing and testing of HDPE straight pipes for sewerage applications havingnominal dia 160 mm in standard lengths not less than 5.0 metres, with co-extruded copper wire as per IS 14333 : 1996, PN-6 pressure rating with a maximum permissible working pressure of 0.6 MPa, MinimumRequired Strength not less than 6.3 MPa at 20 degree celcius, Wall thickness not less than 14.6 mm and not exc. 16.2 mm, alongwith necessary fittings vizbends, tapers, tee pieces single branch, Y junction, collars, caps and plugs etc,including testing the joints with required water pressure complete all as specified & directed. Notes: (i) The quoted rates shall be deemed to be inclusive of jointing the pipes with electrofusion welding and cost of sealant used. The rates shall also be inclusive of all the necessary fittings required at site. (ii) Excavation and earth works shall be measured and paid for separately. 13 Supply and fix ductile iron flanged sluice valve of class 1.6 PNinstalled complete with ISI marked (IS-14846) with gun metal spindle and hand wheelincl nut bolt ,washer rubber sheet etc all as specified and directed by EIC of 150 mm dia bore. 14 S & F Ductile iron non return valve with flanged ends of size 150 mm dia complete incl all jointing materials such as nuts, bolts, washers, rubber gaskets etc all as specified and directedby Engr-in-Charge. 15 Supply, install, testing and commissioning of non clog type submersiblesewage pump with following specifications:- Motor RPM 2900.Degree of Protection IP-68. Frequency 50Hz. Rated Voltage 415 V 3 Phase. Motor body - CI FG 260 With 0.3% NiCuMoPump RPM-2900.Head-Minimum 16 Mtr . Sunction and discharge size - 100mm Direction of rotation- Clockwise from the drive end. Impeller - CI. Minimum Continuous Flow-35 m3/hrsCasing- CI FG 260 With 0.3% NiCuMo. Complete all as specified and directed. 16 Supply and fixing flat copper conductor PVC insulated & PVC sheathed submersible cable as per IS marked of size 25 Sqmm, 3 core working on 1100 volts, 50 Hz supply complete all as specified and directed.Note: Test certificate of cable shall be submit by the Contractor. 17 Supply install, testing and commissioning of factory built assembly of Indor LT panel board mounted on angle iron stand and erected on PCC bed block of suitable size, totally enclosed cubicle type with independent housing to each control with compartmentalised design with powder coated fabricated from CRCA sheet 2 mm thickof size not less than 1200 X 1200 X 300 mm &dust and vermin proof with neoprene rubber gasket and shall be suitable for operation on 440 volts, 3 phase, 4 wire, 50 cycles with including connection from MCCB(incoming) to panel board bus bar and bus bar to out going feeders with suitable size of copper cable and providing lugs, nuts, bolts with washers and insulating the same properlyall as specified and comprising the following :- 18 Incoming:- (a) Aluminium bus bar 03 Nos for phase rating 500 Amp & one for neutral of rating 250 Amp with suitable size and lengthdul;y insulated colour code tap-01 Set(b) MCCB TPN 250 Amp 36 KA thermaladjustable type , 415 volt-01 No (c) Digital type Amp meter three phase size 96x96 mm of rating 400/5 Amp with suitable CTs -01 Set (d) Digital type Volt meter three phase size 96x96 mm of rating 415 Volt -01 Set (e) Indication lamp (RYB) LED type with toggle switch & control fuses - 01 set 19 Out going:- (a) MCCB TPN 160 Amp 35 KA thermaladjustable type , 415 volt-02 No(b) Star deltastarter( ML-4 ) of 25 HP - 02 No. (c)Power capacitor 15 KVAR - 01No .

Key Value

Document Fees
INR 500 /-
EMD
INR 52880.0 /-
Tender Value
INR 26.44 Lakhs /-

Attachment

FileName File Description File Size
Click here to download tender document Tender Documents 0 KB
Click here to download tender document Tender Documents 0 KB
Click here to download tender document Tender Documents 0 KB
Click here to download tender document Tender Documents 0 KB
Click here to download tender document Tender Documents 0 KB
Disclaimer :
We takes all possible care for accurate & authentic tender information, however Users are requested to refer Original source of Tender Notice / Tender Document published by Tender Issuing Agency before taking any call regarding this tender.
Tell us about your Product / Services,
We will Find Tenders for you

Copyright © 2025 · All Rights Reserved. Terms of Usage | Privacy Policy

For Tender Information Services Visit : TenderDetail