Tender For New Construction Work On Mirpur To Saleri Road. - Construction of embankment with approved material obtained from borrow pits with a lift upto 1.5 m, transporting to site, spreading, grading to required slope and compacting to meet requirement of Tables 300.1 and 300.2 with a lead upto 1000 m as per Technical Specification Clause 301.5 complete in all respects but excluding GST. 2 Construction of granular sub-base by providing coarse graded material, spreading in uniform layers with motor grader on prepared surface, mixing by mix in place method with rotavator at OMC, and compacting with vibratory roller to achieve the desired density, complete as per clause 401. complete in all respects but excluding GST. 3 Construction of granular sub-base by providing well graded material, spreading in uniform layers with motor grader on prepared surface, mixing by mix in place methodwith 2% Cement (OPC) with rotavator at OMC, and compacting with smooth wheel roller to achieve the desired density, complete as per Techinical Speficiation Clause 401. complete in all respects but excluding GST. 4 Providing, laying, spreading and compacting stone aggregates of specific sizes to water bound macadam specification including spreading in uniform thickness, hand packing, rolling with smoothwheel roller 80-100 kN in stages to proper grade and camber, applying and brooming, stone screening to fill-up the interstices of coarse aggregate, watering and compacting to the required density Grading 3 as per Technical Specification Clause 405.Including 4% Cement (OPC) & Mising with rotavater) complete in all respects but excluding GST. 5 Brick lining on both side of the road of M-150 bricks 7 cm. wide. 11 cm. deep, laid with mud mortar including labour & supplyof bricks finished to the required template and in proper alignment and also including dressing and ramming the excavated earth as directed by the Engineer-in-charge. SI. No. 763 complete in all respects but excluding GST. 6 Providing and applying primer coat with bitumen emulsion (SS-1) on prepared surface of granular base including cleaning of road surface and spraying primer at the rate of 0.60 kg/sqm using mechanical means as per Technical Specification Clause 502 complete in all respects but excluding GST. 7 Providing and applying tack coat with Bitumen VG-10 using bitumen distributor at the rate of 0.30 kg per sqm on the prepared bituminous surface cleaned with Hydraulic broom as per Technical Specification Clause 503. as per direction of Engg-in-Charge complete in all respects but excluding GST. 8 Providing, laying and rolling of open-graded premix carpet of 20 mm thickness composed of 13.2 mm to 5.6 mm aggregates either using penetration grade bitumen or emulsion to required line, grade and level to serve as wearing course on a previously prepared base, including mixing in a suitable plant, laying and rolling with a three wheel 80-100 kN static roller capacity, finished to required level and grades as per Technical Specification Clause 508. as per direction of Engg-in-Chargecomplete in all respects but excluding GST. 9 Providing and laying seal coat sealing the voids in a bituminous surface laid to the specified levels, grade and cross fall using Type C as per Technical Specification Clause 510as per direction of Engg-in-Chargecomplete in all respects but excluding GST. 10 Supply & fixing of NP-3 class 350 mm dia RCC hume pipe (ISI mark) of following diameters including carriage, loading, unloading at site also including cost of hume pipes & collars & all taxes including laying in proper position & joint filling including cost of necessary jute & cement for propercomplete in all respects but excluding GST. 11 Supply & fixing of NP-3 class 450 mm dia RCC hume pipe (ISI mark) of following diameters including carriage, loading, unloading at site also including cost of hume pipes & collars & all taxes including laying in proper position & joint filling including cost of necessary jute & cement for proper complete in all respects but excluding GST. 12 Supply & Fixing of Kilometer Stone & hectometer Stone complete in all respects but excluding GST. 13 Supplying and fixing of foundation/inauguration granitestone of size 3x2 including cutting, carving etc. compete as per direction of engineer in-charge. complete in all respects but excluding GST. 14 Providing and layingof size 4x3 Sign Board including all taxes etc. compete as per direction of engineer in-charge.complete in all respects but excluding GST. 15 Construction of un-reinforced, (Without dowel Bar) joined at expansion and construction joint only, plain cement concrete pavement, thickness of CC is less then 20 Cm., over a prepared sub base with 43 grade cement or any other type as per clause 1501.2.2(1:1½:3) coarse and fine aggregates confirming to IS 383 maximum size of coarse aggregate not exceeding 25 mm, mixed in a concrete mixer of not less then 0.2 cum capacity and appropiate weight batcher using approved mix design, laid in approved fixed side from work (steel channel, laying and fixing of 125 micron thick polythene film, wedges, steel plates including levelling the formwork as per drawing), spreading the concrete with shovels. rakes, compacted using needle, screed and plate vibrators and finished in continuous operation including provision of contraction and expansion, construction joints as per norms, applying debonding strips primer, sealant, dowel bars, near approaches to bridge/culvert and construction, joints, admixtures as approved, curing of concrete slabs for 14-days, curing compound (where specified) and water finishing to lines and grade asper drawing and Technical Specification Clouse 1501 including Cost of Polythene Sheet and also including complete shifting of materials & Concrete etc. (M-30) S.I. No.Ch.-20 New Item 9(1) 16 Excavation in foundation in soil mixed with mooram. Shingle, Kankar requiring the use of special tools and plant such as pickaxes, sables etc. including all lift and all lead including filling, watering and ramming of excavated earth into the trenches and disposal of suplus earth as directed by the Engineer-in-charge. (As per S.l. No. 251). 17 Providing and laying in cement concrete 1:4:8 (1 cement 4 coarse sand : 8 graded stone ballast 40mm nominal size) and curing complete, including supply of all materials, labour and T&P etc. required for proper completion of the work as per direction of E/I) S.I. No. 281 18 R.C.C. Work with cement approved coarse sand & 2 cm gauge approved stone grit in proportions of 1:1.5:3 in lintels of door & windows excluding supply of reinforcement and its bending, but including its fixing and binding the same with 24 B.W. G.G.I., binding wire and including necessary centering and shuttering etc. and supply of all materials labour, Tools &plants etc. required for proper completion of the work, including cost of binding wire. The rate excludes making of drip course which shall be paid extra. SI No. 284 19 M.S. (tor steel or plain) in Plain work such as R.C.C. or R.B. work including bending for proper shape and including supply of steel & its wastage, bend hooks, and authorized overlapping shall be measured and including cost of binding wire. SI.No. 504
