Tender For Provision Of Misc Stores At Rms, dimapur-Nagaland

Tender For Provision Of Misc Stores At Rms; Ordinary Portland Cement grade 43, IS-12269-1900 packed in 50 kgs HDPE bags conforming to 151 1652/2000 (Make: ULTRA TECH/AMBUJA/ACC/DURAGUARD) 2 Coarse Sand Sand shall be clean, sharp, angular hard and durable free from adherent coating and shall not contain clay, mica and other impurities. The maximum quantities of clay and fine silt in sand shall not be more than 5% by mass as per IS-383-1970. 3 40mm Stone Aggregates Stone aggregate shall be crushed stone 40mm graded conforming to IS-383-1970 and shall be clean hard tough, durable and of uniform quality throughout. The aggregate shall be free from soft disintegrated materials, vegetable and other organic impurities Mild steel rolled angle iron section 65 x 65 x 6mm fencing post 3.75mtr long conforming to IS 2062-1984 including drilling holes for fencing, fabrication of 0.75m long for swan neck on top at 45 to vertical, welding of two nos of 12mm MS rod 200mm length to bottom for anchorage painted with one coat of red oxide primer and two coats of synthetic enamel paint for the exposed surface of angle above GL and two coats of bituminous paint to embedded portion (0.60m), weight of each picket not less than 21.75Kg 5 6 7 8 9 Mild steel flat iron 40 x 5mm, 2.4m long incl drilling holes for fencing and one coat of red oxide primer and two coats of synthetic enamel paint ISI marked Mild steel round bars 10mm dia and over including one coat of red oxide primer and two coats of synthetic enamel paint Galvanised mild steel chain link fence fabric 2.4m wide, mesh size 65mm x 65mm (+/-3.25mm) of 4.00mm nominal diameter of wire conforming to IS: 4826 Structural steel rolled section angle iron 60mm x 60mm x 6mm, 2.70m long 14.58 Kg per picket conforming to IS2065-1984 including fabrication for strut post bend at top portion including making three Nos holes of 15mm dia including 0.23m, 16mm dia MS rod two pieces to be welded at bottom for anchoring purpose including one coat of red oxide primer and two coats of synthetic enamel paint for exposed surfaces of angle above GL and two coats of bituminous paint on embedded portion of strut 0.60 mtr below GL (Make TATA/SAIL/JINDAL). The iron angle shall be provided with MS plate of thickness 3mm and size 15mm x 15mm welded at the bottom and Mild steel machine made 12mm dia and 50mm long bolts with hexagonal head at one end and screwed on the other end, fitted with nut and 10 Galvanised steel two strand barbed wire 2.24mm dia of wire, 2 mm dia barbs at 75 mm spacing confirming to IS:278 of 1978 11 Gl binding wire 1.20mm dia 12 Ply wood 12 mm thick 8x4 13 Wooden scantling 50mm x 50mm 14 Nails 4 long 15 Synthetic enamel paint 16 Paint brush 2

INR 2000 /-

INR 40000.0 /-

Refer document