Tender For The Supply Of “Spray Pyrolysis Equipment And Accessories Coating Chamber: 1. Programmable spray movement: Compact XYZ system that f 150 mm x 100 mm range of motion and highly functional with 2. Drive speed X-axis: 10 to 800 mm/s 3. Drive speed Y-axis: 1-12 mm / sec 4. Enclosed Chamber with glass window for sample loading 5. Provision for holding a nozzle with XYZ system 6. Microcontroller based control panel 7. Exhaust 8. Spray area: 10 cm x 10 cm 9. Mention Full chamber dimensions II. Substrate Heater: 1. Heater Area: 150 x 150 mm 2. Maximum substrate temperature: 500℃ 3. PID temperature controller to control the heater temperature 4. PC connectivity: RS232 port III. Ultrasonic Spray Head with Syringe pump: IV. Dispenser: 1. Capacity: 50ml and 250 ml 2. Microprocessor controlled piston movement 3. Piston Actuator: Stepper motor 4. Dispensing Rate : 1- 10 ml/min adjustable via software 5. Container Material: Glass and Nylon V. User interface: PC & Software control 1. Branded PC/ laptop computer with high-end configuration - I No. (With pre-installed software). 2. PC/Laptop interface. Software controllable parameters: XY travel. Z control is manual speed, dispensing rate, delay and coating duration. 3. XY/ spray duration: I min to 60 min 4. Stationary spray duration: I see to 240 sec 5. All of the process parameters can be saved as a user process and retrieved later for analy sis or re-run VI. Compressor / Generator 1. One compact compressor: Compressed air with a pressure of 8 psi to 12 psi is required for normal operation of the unit 2. Pressure control; Built-in pressure regulator 3. Power: 1 hp 4. Generator should operate at 40 KHz frequency. VII. Input Supply Voltage: 230V. 50Hz VIII. Installation Commissioning and Training
We takes all possible care for accurate & authentic tender information, however Users are requested to refer Original source of Tender Notice / Tender Document published by Tender Issuing Agency before taking any call regarding this tender.
