Tender For Electrification Work Of Pre-Constructed Toilets Of Gomti River Front Lhs. - Supply And Fixing Of Recess/Surface/ Pendent Mounting Round 10 To 15 Watt Led Down Lighter Having Powder Coated Die Cast Aluminium Housing With Heat Sink, Diffuser/ Ref, lucknow-Uttar Pradesh

Electrification work of pre-constructed toilets of Gomti River Front LHS. - Supply and fixing of recess/Surface/ Pendent mounting round 10 to 15 Watt LED Down Lighter having Powder coated die cast aluminium housing with heat sink, diffuser/ Reflector and driver set complete in all respect. As per PWD schedule 2018 SI No. 1402 CAT AAA 2 Supply and fixing of 36 Watt to 46 Watt indoor Recess mounting LED Square Pitting for Armstrong Ceiling having Powder coated die cast aluminium housing body with extended heat sink and diffuser of Special Polycarbonate meterial and driver set complete in all respect. As per PWD schedule 2018 SI No. 1406 CAT AAA 3 Supply & Fixing of 1200 mm ceiling fan complete in all respect as per direction by E/lc. (PSR) Rate 4 Supply and fixing of 250 mm size vaintilation fan Including making hole in the wall exhaust fan and finishing properly complete in all respect (PSR) 5 Supply and fixing of wall fan 400 mm swing (white color) Make havells. And Crompton 6 Supply and wiring of 2 nos 2.5 sq.mm. FRLSH PVC insutlated 1100Volt grade multistrand single core copper conductor cable in 25 mm dia heavy duty (2 mm thick) PVC conduit with 2 nos 2.5 sq.mm. FRLSH PVC insulated multistrand copper conductor cable as earth continuity wire drawn in conduit. As per PWD schedule 2018 SI No. 256 (C) 7 Supply and erection of factory fabricated and wired metal clad dust and vermin proof floor mounting panel TPN switch board complete with the following HRC type heavy duty TPN fuse switches with fuses and instrument chamber etc. complete in all respects. The instrument chamber shall be separate and shall comprise of flush type ammeter, voltmerer, selector switches for ammeter and voltmeter, instrument fuses, current transormer etc. The board shall have suitable capacity electroytic alumininum busbars as per 158623 istulate with heat shrink sleeving and mountend on non hygroscopic supports such as CMC/DMC support with deteachable side covers and shall be suitable for extension on the sides. The switches shall be complete with suitable cable end boxes, reverse entery boxes in case of pedestaal type, cable sockets, compression glands and indicating lamp on incoming etc. The job includes the grounting of the board as per direction of Engineer-in-Charge. All coutgoing switches of 100 Amp. and above will be provided with ampere metre current transformers and selector switches and instrument fuses etc. The switches board shall be fabricated with CRCA sheet with a minimum thickness of 1.6 mm/2 mm. Cubicle type switch board shall be of cat A B & B-II and pedestal type for Cat-B and C only. As per PWD schedule 2018 SI No. 801 (c) 8 Incoming 9 100AMP TPN-1 No. 10 Outgoing 11 (c) 63Amp TPN-1 & 32AMP TPN-2 Nos. 12 Supply and burying of 600mm x 600mm x 6mm G.1. plate vertically for earthing with its top at least 3 metres below ground level complete with 20mm dia G.I. pipe and funnel for watering and one earthing lead of two no. 8 to 10 SWG GI wire in 15mm dia G.I. pipe up to switch board (from appron to switch board the cost of G.I. pipe and G.I. wire will be extra) 30cm square C.l. frame with hinged cover masonry housing alternate layers of charcoal/coke and salt at least 150mm thick alround etc. as per directions of Engineer-in- charge complete in all respect. As per PWD schedule 2018 SI No. 703 13 Supply and laying of aluminium conductor PVC insulated armoured served sheathed cables 1100 Volts grade at a depth of 750 mm below ground level over a cushion of 75 mm. thick sand all around and protected with burnt bricks on sides and on top. On surface the cable run shall be fixed on M.S. clamps etc. of suitable size or as directed by the Engineer-Incharge, complete in all respect. The armouring of the cable shall be properly connected with the earth conductor by clamps etc.As per PWD schedule 2018 SI No. 501(J) 14 25 sq. mm 3-1/2 core 15 Supply and fixing of 6amp to 32amp SPMCB(10KA) C Curve As per PWD schedule 2018 SI No. 1002 CAT A 16 Supply and fixing of 63amp S.P isolator As per PWD schedule 2018 SI No. 1004(B) 17 S & F surface/Flush mounting 4ways TPN distribution board without additional Door without MCB complete in all respect, as directed at site by Engineer in charge. As per PWD schedule 2018 SI No. 1026 CAT A 18 Wiring point for exhaust fan with 1.5 sq. mm.FRLSH PVC insulated multistrand single core copper conductor cable in heavy guage rigid steel conduit partly concealed in wall and partly laid in slab alongwith the reinforcement before concreting, complete with 14 13 SWG copper earth continuity wire, GP Box, 15A piano type switch & ceiling rose on 3 mm thick phenolic laminated backelite sheet etc., complete in all respect including matching colour wash. As per PWD schedule 2018 SI No. 1448 19 Wiring point for plug with 1.5 sq. mm.FRLSH PVC insulated multistrand single core. copper conductor cable in heavy guage rigid steel conduit partly concealed in wall and partly laid in slab alongwith the reinforcement before concreting, complete with14 SWG copper earth continuity wire and piano type switch and socket etc., complete in all respect including matching colour wash. As per PWD schedule 2018 SI No. 141-B 20 Wiring point for fan / fresh air fan (light duty exhaust fan) with 1.5 sq.mm.FRLSH PVC insulated multistrand single core copper conductor cable in heavy guage rigid steel conduit partly concealed in wall and partly laid in slab alongwith the reinforcement before concreting, complete with 14 SWG copper earth continuity wire,GP Box, piano type switch & ceiling rose on 3 mm. thick backelite sheet etc., complete in all respect including matching colour wash. As per PWD schedule 2018 SI No. 140 В 21 Wiring point for light with 1.5 sq. mm.FRLSH PVC insulated multistrand single core copper conductor cable in heavy guage rigid steel conduit pipe partly concealed in the wall and partly laid in slab alongwith the reinforcement before concreting, complete with 14 SWG copper earth continuity wire, GP Box, piano type switch & ceiling rose/angle/batten holder on 3mm thick phenolic paminated backalite sheet etc complete in all respect as directed including matching colour wash. As per PWD schedule 2018 SI No. 1388

INR 767 /-

INR 23800.0 /-

INR 4.76 Lakhs /-