Supply, delivery and installation of Automatic plunger type chlorinator having flow rate of 0 - 100 LPH and maximum pressure of 10 kgf/cm2 at Katabani O.H.R site of Barasukjora water supply scheme at Binpur-II block of Jhargram Dist. under Jhargram Mechanical Division P.H.E. Dte.- 1 6 way SP&N Double Door horizontal Distribution Board (I/C 2 + O/C 4) conforming to IS 13032 & IS 8623 and IP42/43. Make :- As per approved vendor list of PHED vide no.8864/79/F/2018 dated 28/06/2024 with latest amendments 2 6-32 Amp Amp,10 kA, 240/415V, 50 Hz SP MCB conforming to IS / IEC: 60898-1, C characteristics. (6 Amp- 1 nos.,10 amp-1 no, 16 Amp-1 no.) 3 Hard wooden board (450mm X 304.8 mmx 2 mm thick) 4 63 Amp, 240/415 V Porcelain fuse unit (Base & Bridge)Make :- As per approved vendor list of PHED vide no. 8864/79/F/2018 dated 28/06/2024 with latest amendments 5 16 Amp,10 kA, 240/415V, 50 Hz SPN MCB conforming to IS / IEC: 60898-1, C characteristics.Make :- As per approved vendor list of PHED vide no.8864/79/F/2018 dated 28/06/2024 with latest amendments 6 63 Amp ,10 kA, 240/415V, 50 Hz SPN MCB conforming to IS / IEC: 60898-1, C characteristics.Make :- As per approved vendor list of PHED vide no.8864/79/F/2018 dated 28/06/2024 with latest amendments 7 2 waysheet steel MCB enclosure. Make :- As per approved vendor list of PHED vide no.8864/79/F/2018 dated 28/06/2024 with latest amendments 8 63 Amps, 415 V ,4 way Bus-Bar chamber having 4 nos. Copper Bar.Make :- As per approved vendor list of PHED vide no. 8864/79/F/2018 dated 28/06/2024 with latest amendments 9 LED street light luminarie IP 66 LM6-HPDC Housing Street light aerodynamically designed with better thermal management/ Potted driver is to be provided,the luminaire and housing should be from the same manufacturer(cat no- BRP052 LED 045 CW SLMR FG S1 PSU GR ,System Efficacy greaterthan 100 lumen/watt) Make-Philips OR Equivalent and same techinal specification ofHavells.The manufacturer has to provide LM79/LM80 reports corresponding to the luminaire/LED Chip along with type test Certificate.Respectively the luminaire manufacturer should have an in house NABL Accredited testing facility. 10 Supplyof chlorination system with all equipment and accessories as per following specification:- 1 no. dosing pump of capacity 0-100 lit/hr. max. discharge and 10 Kg/cm². pressure maxwith Motor 0.5 HP, 1 Ph, 50Hz 220 Volt, 1440 rpm TEFC cooling motor, base plate rate adjustment device etc. ii. 100 lit HDPE dosing tank for storing of chlorine solution. iii. Necessary GI pipe fittings and HDPE / PVCpipe line for dosing the solution with all accessories as per requirment. Pump Make :- As per approved vendor list of PHED vide no.8864/79/F/2018 dated 28/06/2024 with latest amendments 11 1.1 KV Grade 415 V, 2 core 10 sq.mm. PVC sheathed XLPE insulated Al. armoured cable conforming to IS:7098 (PART-1) 2011 with latest amendmends as applicable.Make :- As per approved vendor list ofPHED vide no.8864/79/F/2018 dated 28/06/2024 with latest amendments 12 PVC mouldedchair without arm.(Make:- Nilkamal/Supreme/Cello) 13 Fitting-fixing of the supplied wooden board at suitable position on wall with fitting-fixing of supplied 63 Amp Porcelain fuse units (as in item no. h) on the board by supplying and fitting-fixing of required nos. of nuts-bolts-washers etc. all complete as per direction of E.I.C 14 Fitting-fixing of the distribution board on flat /angle iron frame at desired position on wall of pump house with supplying & fitting-fixing of required nos. of nuts, bolts, washers etc. with necessary earthing arrangement from nearest earth grid by G.I. wire/ strip all complete as per direction E.I.C. This includes the cost of fitting-fixing of the Isolator & MCBs within the DB including necessary power connections by 2.5 mm2 FRLSH copper wire (Havells /KEI/Finolex/Gloster/polycab/other approved make) all complete. 15 Fixing only MS sheet metal busbar Chamber on angle iron frame on wall 16 Supply fitting fixing PVC pipe for underground work approved make of Schedule 80 (medium duty) conforming to ASTMD - 1785 and threaded to match with GI Pipes as per IS : 1239 (Part - I). with all necessary accessories, specials viz. socket, bend, tee,union, cross, elbo, nipple, longscrew, reducing socket, reducing tee, short piece etc. fitted including cost of all materials ,jointing materials, cutting pipes, making threads ,cutting trenches upto 1.5 metre below surface in all sorts of soil andrefilling the same as directed complete in all respect. (Payment will be made on the centre line measurement of the total pipe line including all specials No separate payment will be made for accessories,specials.)15 mm dia. 17 Supply, delivery & installation of Starter for the above chlorine machine.single phase, 240V Overload relay range: 3.50 - 6.50 Awith UV coil Make: L & T/ BCH/any other approved 18 Installation of above supplied Chlorine machine by supplying & drawing of of suitable length 1.1 KV grade 2x36/0.3 (2.5 sqmm) single core stranded FRLSH PVC insulated & unsheathed copper wire (approved make) from installed panel board through 20 mm PVC rigid conduit FR (Precision make) incl. necy. fitting as required and continuous earthing from nearest earth grid.This includes the cost of making required height bricks foundation base with neat cement finishing by supplying all required materials and testing the entire set as per direction of E.I.C. Height of foundation shall be higher than that of chlorine machine. 19 Making internal wiring/electrification of the Pump house by (2x 22/0.3 (1.5 sqmm) + 1x 22/0.3 (1.5 sqmm) single core PVC insulated multistrand FRLSH Grade flexible copper wire through 20 mm PVC conduit pipe/casing by supplying one no. 40 Amp, 10kA, 240/415V,50 HzSPN/DP MCB Isolator conforming to IS / IEC: 60947-3, C characteristics. (As per approved vendor list of PHED vide no. PHE/IV/2277/W-181/19 dated 25.09.2019) with required module PVC Board & piano key type switch. (ave. run 6 mtr). i) LED Tube set point-2 nos., Bulk Head light point- 1 no., 5 pin 6 Amps. Plug point- 1 no., 16 Amp socket & switch- 1 no, indicator- 1 no. each,with necy. earthing arrangement & one fan point (Total point 6 nos. points) including drawing power by suitable gauge (2.5 mm2) of copper wire from installed cut-out to SPN/DP MCB within DB through 20 mm PVC casing capping (precision make) as per direction of EIC (fittings should be of Philips make & wiring should be with continuous earthing arrangement and 20W two nos. 4 ft long LED tube light setsPHILIPS Astra Line, one no. bulk head (Endura WT202W LED6S NW PSU S2 PC), one no. 0-4 step fan regulator (Humfree), fittings etc to be supplied by agency). 20 S&F of 3 dia 1.5 mt minipole with baseplate to be fixed on rooftop incl. S&F of 1.5 mtr long arm bracket (removable type) incl. CC (6:3:1) muffing(450X450X600) with 3 mm thick neat cement finish & painting incl. S&F of 200x150x100 mm 16 SWG GI loop box with necessary power connection by3x 22/0.3 (1.5 Sq.mm) (2 nos. P&N and 1 no. ECC) FRLSH PVC insulated & unsheathed copper wire (Approved make) in 20 mm size PVC rigid conduit FRLSH (Precision make) incl. necy. fittings as required as per direction of EIC. 21 Laying of cable (as in item no. 11) on wall/surface incl. S & F of MS saddles with earthing attachment in 10 SWG GI (Hot Dip) wire, making holes etc. as necy. mending good damages and painting all complete as per direction of E.I.C. 22 Supplying and fixing of compression type gland complete with brass gland, brass ring & rubber ring for dust & moisture-proof entry ofcable (as in item no.11 all complete as per direction of E.I.C. 23 Finishing the end of cable (as in item no. 11) by crimping method incl. supplying and fixing solderless socket (Dowels make), tapes, anticorrosive paste & jointing materialsall complete as per direction of E.I.C. 24 (a) Earthing with 50 mm diameter G.I. pipe 3.64 mm thick x 3Mtr. (10ft.) long and 1 x 4 SWG G.I. wire (4Mtr.long) 13 mm diameter x 80mm (3inch) long G.I. Bolts, double nuts, washer including S & F of 15mm diameter G.I. pipe protection (1 Mtr. Long) to be filled with bitumen partly below ground level to an average depth of 3.65Mtr.(12ft.) below the ground level and restoring the surface duly rammed.i) For soft soil by ISI Medium GI pipe. 25 (b) Extra for providing masonery enclosure on the top of the earth electrode of overall size 86.36 cm x 86.36 cm x 46 cm deep (below Ground level) complete with cemented brick work(1:6) of 25 cm width duly plastered with cement morter (inside) CI hinged inspection cover of size 36.56 cm x 35.56 cm with locking arrangement, GI reducer including drilling of 46 nos. 12 mm diaholes on the GI pipe. 26 (c) Extra for treatment of soil by salt and charcoal coke for pipe electrode. 27 (d) Supplying & fixing earth busbar of galvanized (Hot Dip) MS flat 25 mm x 6 mm on wall having clearance of 6 mm from wall including providing drilled holes on the busbar complete with GI bolts, nuts, washers, spacing insulators etc. as required.Length of busbar is 0.5 mtr. 28 (e) Connecting the equipments body to earth busbar including S&F 20 mm x 3 mm galvanised (Hot Dip) MS flat on wall/floor with GI saddles as required and connection to equipments incl. drilling holes, with bolts, nuts, washers etc. 29 Supply, delivery and fitting-fixing of 230 volt1200 mm sweep AC ceiling fan withball bearing complete with all accessories such as blade, canopy, fork, down rod etc. Make :- As per approved vendor list of PHED vide no. PHE/IV/8864/79/F/2018 dated 28/06/2024 with latest amendments 30 chlorine Modification system1/2mm dia ball valve (PVC) 31 1/2 non return valve(G.M) 32 1/2 mm dia GI tee 33 1/2 mm dia Gl elbow 34 1/2 mm dia Gl short pipe 35 1/2 tail piece 36 1/2mm dia ms clamp 37 1/2 mm dia PVC tank connector 38 1/2 dia breaded hose pipe 39 25mm dia ball vaive 40 25mm dia union (PVC) 41 25mm dia elbow (PVC) 42 25mm dia PVC pipe (Sch 80) 43 25 mm dia tank connector 44 25 mm dia G.I. socket 45 100 liter capacity loft tank ( white) Make-Syntex/any other approved make 46 supply and delivery of iron angle frame for installationof tank in which hypocloride solution mixed with water(frame weight 22 kg approx) 47 Dismantling the all mechaical connection of existing chlorine machine for modification work as per direction of E.I.C 48 Modification of disinfection arrangement with newly supplied materials including necessary fitting fixing materials as per direction of E.I.C 49 Testing of the whole installation with demonstration to the agency labour engaged as pump operator & upto entire satisfaction of E.I.C 50 Add GST @ 18 % 51 Add Cess @ 1 %
