Tender For Pr-28038465_Lv Mcc Panel_Infr, Hazira-Gujarat

Tender For Pr-28038465_Lv Mcc Panel_Infr 28038465 0001 0001 300923646 SYS,OT,LVMCCPANELEXTENSION Technical Details Name : Paresh Joshi Contact : Email : PARESH.JOSHI@AMNS.IN 1 VAL SYSTEM,ONE TIME DETAILS:LV MCC PANEL EXTENSION DETAILS-1:TECHNICAL SPECIFICATION ATTACHED : H019-MHI-MHS4-CVS-E-TSP-006 AMNS REF. NO(WBS):C-22-UPSTR-INFRA-SDI2 Item Details : AMNS SCOPE • AMNS WILL SHARED THE TECHNICAL SPECIFICATION AND EXISTING PANEL DRAWING TO VENDOR FOR MCC EXTENSION WORK. Vendor Scope of Supply with MCC extension • VENDOR TO SUBMIT GA DRAWING, QAP, AND TECHNICAL DATASHEET ALONG WITH OFFER/QUOTATION FOR NECESSARY TECHNICAL EVALUATION PURPOSE. • BEFORE FINALIZING THE SCHEME <(>&<)> GA DRAWING OF PANEL VENDER SHOULD BE VISIT TO LOCATION TO UNDERSTAND OUR CORRECT REQUIREMENT AND UNDERSTAND THEIR SCOPE OF WORKS, ANY ITEM WHICH IS NOT INCLUDED IN THE SCOPE OF WORK BUT NEED TO BE REQUIRED FOR THE COMPLETENESS OF THE PROJECT SHALL BE INCLUDED BY THE BIDDER. • VENDOR TO SUBMIT ALL INTERNAL INSPECTION REPORTS AND MOC TEST CERTIFICATES NEED TO APPROVE BEFORE DISPATCH OF THE MATERIAL • PANEL HEIGHT DEPT AND BUSBAR SIZE WILL SHARE THE EXISTING PANEL DRAWING SHARED BY M/S AMNS WITH TECHNICAL SPECIFICATION. HOOK UP OF NEW PANEL WITH EXISTING PANEL INCLUDING CONTROL AND POWER BUS AND WIRING WITH SUPPLY WILL BE IN VENDOR SCOPE. • DIMENSIONS: TO BE DECIDED DURING ENGINEERING. • PANEL MOUNTING PLATE TO BE PROVIDED WITH THE PANEL SO THAT IT CAN BE FIXED EASILY ON THE FLOOR • THESE PANELS SHOULD DESIGN AS FRONT <(>&<)> REAR ACCESS, NON-COMPARTMENTALIZED <(>&<)> WITH BOTTOM CABLE ENTRY. THE BUSBAR CONSIDERED IS OF HIGH-QUALITY ELECTROLYTIC GRADE ALUMINIUM FOR WHOLE PANEL. • INDICATION LAMP TO BE PROVIDED AS PER EXISTING PANEL • INCOMER VOLTMETER <(>&<)> AMMETER WITH VSS AND ASS. • POWER WIRING INSIDE THE PANEL SHOULD BE DONE USING SINGLE CORE FLEXIBLE GREY COLOUR COPPER CABLE OF SUITABLE RATING. • SUPPLIER SHOULD SEND BOM ALONG WITH TECHNICAL OFFER. • SUPPLIER SHOULD SUPPLY THE SHROUD FOR O/G CABLE CONNECTION AS PER EXISTING PANEL <(>&<)> PROVIDE LOTO PROVISION WITH THE SUPPLY FEEDER • PANEL MANUFACTURE SHOULD BE STARTED ONLY AFTER GA APPROVAL. • MDCC WILL ISSUE AFTER FAT AT VENDOR WORKSHOP WITH PRESENT OF AMNS ENGINEER. • INSTALLATION, TESTING AND COMMISSION WITH EXISTING PANEL WILL BE IN VENDOR SCOPE • IN CASE OF ANY FAILURES OR DEFECTS, THE VENDOR MUST PROVIDE NEW ITEMS AT THEIR OWN COST WITH SERVICE SUPPORT ON IMMEDIATE BASIS • AS-BUILT DRAWINGS MUST BE PREPARED O

Refer document

Refer document

Refer document