Tender For Provision Of Covered Shelter At Main Gate Of Cg Enclave Chicolna Under Ge(I)(Cg) Goa; 1 Excavating over areas, n exc 1.5 m deep and getting out soft and disintegrated rock. Complete all as specified and directed. 2 Removing excavated material in exc. 50m and depositing or soft and disintegrated rock. Complete all as specified and directed. 3 Returning, filling in, including spreading, levelling, watering and well ramming in layers not exc 25 cm for soft and disintegrated rock. Complete all as specified and directed. 4 M & L Cement concrete type D2 using 40mm aggregate in ratio 1:4:8 in foundations, filling and mass concrete. Complete all as specified and directed. 5 M&L RCC M30 Design mix concrete using 20mm graded aggregate as in Foundations, including rafts, footings, foundation beams: plinth beams, bases for columns, etc; basement slabs. under-reamed piles and mass concrete. Complete all as specified and directed. 6 M & L RCC M30 Design mix concrete using 20mm graded aggregate as in coloumns, pillar, piers, posts and struts. Complete all as specified and directed. 7 Formwork to sides of concrete foundations, footings, bases of columns, raft and raft beams, sides and soffits (if any) of foundation and plinth beams; and similar work; vertical or to batter flat rough finish surfaces of concrete. Complete all as specified and directed. 8 Formwork to sides of pillars, posts, struts, piers, columns and stanchions rough finish surface of concrete, square/ rectangle. Complete all as specified and directed. 9 M&L Reinforcement TMT bars 10mm dia & over, cut to length, bent to shape required including cranking, bending spirally far hooping for coloumns, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9mm dia or securing with clips quality conforming to Fe-500. Complete all as specified and directed. 10 Ditto, as per item no 9.. But 6mm to 8mm dia. Complete all as specified and directed. 11 Supply and fix Rolled mild sections single stanchions of square hollow sections with flange plates, caps, bases, splices, angle brackets, cleats and other connections Fe 410-W (Gde E-250) quality A. Complete all as specified and directed. 12 Plate girder or single stanchions, built up of one beam or channel section with flange plates, caps, bases, splices, angle brackets. cleats and other connections. Complete all as specified and directed. 13 Plates (plain or chequered) channels, square cut or notched (ordinary and counter sunk) forming holes, without any attachment. Complete all as specified and directed. 14 Supply and fix mild steel framed work such as grills grating etc with ends of bars shouldered and/or riverted or forged into spikes framed guard bars barred iron doors, ladders, framed balustars, Walk ways railings, frame work of water tanks and similar work. Complete all as specified and directed. 15 Mild steel bolts. purpose made, with hexagonal or square head one end and screwed the other, or screwed both ends, each screwed end to be fitted with washers and one hexagonal or square nut exc 30cm long. Complete all as specified and directed. 16 Supply and fix pre painted galvalume aluminium zinc coating GI based corrugated steel sheet 0.50 mm of an colour having tensile strength of 550 MPA as in roof covering/cladding fixed with self tapping screws. Complete all as specified and directed. 17 M&L of new steel surfaces of any description over 10 cm in width or girth and applying two coat of synthetic enamel paint over a coat of red oxide primer. Complete all as specified and directed. 18 Supply and fix High Bay Luminaire 150 W, 230 V AC outdoor type with high pressure die cast housing, round shaped LED Highbay luminarie with PC Diffuser & 120 lm/W efficacy. Equipped with 4KV in-built & 10 KV External surge protection and heat resistant complete with driver, lamp bracket with impact and corrosion resistant including thermal management in multiple optics complete with IP 65/66 protection. Complete all as specified and directed. 19 Supply and fix Hot press moulded SMC boxes of size 300 x 200 x 105 mm with one No. MCB SP 10 Amps, connector 4 way 16 Amps including fixing clamps, nut bolts etc complete as street light terminal boxes. Complete all as specified and directed. 20 Supply, laying and testing cable XLPE Insulated,screened, PVC bedded, galvanized steel strip or wire armoured, electric power cables (heavy duty) 1100 Volts grade with stranded aluminium conductor of size 10.0 sq mm 2 core. Complete all as specified and directed. 21 Supply and fix Digital Weekly Programmable Time Switch (SST -1) with Automatic Modular Contactors - TP 4P Rating 16A, contactor of 3 NO that width in multiple of 1 module (18mm) placing in SMC box. Complete all as specified and directed.
