Tender For Welcome Maintenance To Md Accn At Mil Stn Dharamshala Cantt; 1 Taking down chokhats or frames including shutters (without taking off shutters from the frame) not exc. 1.5 sqm each and removing from site, all as specified. 2 Taking down chokhats or frames including shutters (without taking off shutters from the frame) exc. 1.5 but not exc. 4 Sqm each and removing from site, all as specified. 3 Taking down shutters not exc. 1.0 Sqm and removing from site, all as specified. 4 Taking down shutters exc. 1.0 Sqm but not exc. 2.0 Sqm each and removing from site, all as specified. 5 M&L for taking down shutter of any description exc 1 sqm and n.exc 2 Sqm each and refixing in same opening after easing and adjusting complete all as specified and directed. 6 2nd class hard wood (Sal/Hollock) plain, solid, straight chowkhats or frames, wrought, framed, rebated on solid, rounded or chamfered, put together with glue, pinned at joints with one or more rebates, complete all as specified. 7 S&F 35mm thick Ist class softwood Glazed and skeleton shutters, open rebated and prepared to receive glass, gauze, etc. (without sash bars), edges of framing plain, chamfered or rounded. fitted with cut and mitred beads for securing glass, etc.; sizes of me-mbers of shutters as specified in SSR Part I, Section 8, clause 8.24 (a); supplied and fitted to chowkats complete all as specified and directed by Engr in Charge. 8 Factory made 2nd class hard wood (Sal/Hollock) plain, framed, panelled 35mm thick shutters (two panels ) with lock rail and panels of 9mm BWP commercial plywood or 12mm veneered particle with commercial face veneers on both sides. The size of rail and style as per IS-1003 (Part-I), kiln seasoned and chemically pressure treated, all as specified. 9 Solid PVC frame (Single Rebated) of size 60mm x30mm made out of solid PVC foam with homogenous fine cellular structure having smooth outer integral skin with suitable metal stiffner and fixed with 100 x 8 sheet metal CSK screws complete as shown on page No176 to 183 of MES SSR 2020 Part-II compete all as specified and directed.(Note :- Door frame shall be water proof, termite proof, elegant and should have excellent screws holding strength to fix hinges and hold doors properly for a long life) 10 Factory made solid panel PVC door shutter 30 mm thick (style) consisting of frame made out of M.S. tubes for top & bottom rails.M.S. frame shall be covered with heat moulded plain colour PVC ‘C’ channel having a PVC sheet strip of 20mm width stuck inside with solvent cement for stiles and Plain colour PVC sheet for top rail, lock rail & bottom rail on either side & as gap insert for top rail & bottom rail; panelling of plain colour PVC sheet to be fitted in the M.S. frame welded/ sealed to the stiles & rails with suitable PVC sheet beadingand joined together with solvent cement, suppling & fixing in the frame at site, as per specification compete all as specified and directed. 11 Aluminium, anodised, barrel tower bolts of extruded section and fixed with 100mm long bolt. 12 Butt hinges, medium weight, cold rolled, mild steel 100 mm long, all as specified. 13 Anodized aluminium alloy handles, fabricated type, anodised or size 150mm, complete all as specified. 14 Anodized aluminium alloy handles, fabricated type, anodised or size 100mm, complete all as specified. 15 300mm long anodized aluminium alloy sliding door bolt, bolt type, stove enamelled black, with bright bolt not less 16mm dia, with and including a minimum of 6 bolts and nots, 4 on bolt plate and 2 on stapple plate, 300mm long, all as specified. 16 Sheet glass 3mm thick ordinary quality and glazing with oil putty/wooden beads in squares, not exc. 0.5 Sqm in each pane, all as specified. 17 S&F figured glass pin head type 3mm thick ordinary quality and glazing with oil putty n exc 0.5 sqm in each pane. 18 S&F soap dish any type fixed to plugs with chromium plated brass screws all as spd and directed 19 S & F in repairs Toilet paper holder recessed type stainless steel complete all as specified 20 S & F in repairs brass chromium plated tubular towel rail, 20mm dia, D type 60cm long between flanges all as specified 21 S&F Glass/PTMT shelf with CP railing fancy type complete all as specified. 22 S&F Glass/PTMT corner shelf with CP railing fancy type complete all as specified. 23 S&F (600mm x 450mm) bevelled edge mirror of selected quality glass mounted on 6mm thick AC building board or commercial plywood with aluminium frame 15 x 15 and fixed to wooden plugs with chromium plated brass screws and cup washers complete all as specified. 24 Mild steel galvanized wire cloth 0.56mm nominal dia of wire and average width of aperature 1.18 mm fixed with tinned tacks or wire staples or wooden beads, all as specified, fixed in repair. 25 Preparation of New wooden surfaces of any description and otherwise described over 10 CM width or girth and applying two coats synthetic enamel paint over one coat of pink primer complete all as specified and as directed by Engr-in-Charge. 26 Taking down cement plaster on brick or stone surfaces etc. including raking out joints, hacking for key, scrubbing down with water etc. all as specified. 27 M&L for 15mm thick plastering in cement mortar 1:4 on stone masonry surfaces or other than fair faces of brick surfaces, finished even and smooth without using extra cement, complete all as specified. 28 Rendering 10mm thick cement plaster on fair faces of brick work or concrete surfaces in cement mortar (1:6) finished even and fair without using extra cement all as specified and directed. 29 Preparation of newly plastered wall surfaces and applying two coats of cement base paint including preparation of surfaces, complete all as specified. 30 Preparation of newly plastered wall surfaces and applying two coats of oil bound distemper over a coat of chalk whitening preparatory to distempering including preparation of surfaces, complete all a specified. 31 Taking down GI pipe of 15mm bore etc. complete all as specified and directed by Engr-in-Charge. 32 S&F 15mm bore GI tubing medium grade galvanized with all fittings and fixed complete to walls and ceiling or laid in floor/wall. 33 Refixing only old GI tubing 15 mm bore pipe and connections in new or old position as on walls ceiling floors etc all as specified. 34 Demolition of cement concrete in ground floors and paving, not exceeding 15cm thickness (below or above ground level), un-reinforced, complete, all as specified. 35 Dismantling floor, hearth or wall tiling incl cement mortar bedding 36 PCC M-15, nominal mix, type B-1, using 20mm graded mechanically crushed stone aggregate as in floors, 25mm thick, finished even and rough to receive floor finishes, complete, all as specified. 37 S&F vitrified ceremic coloured light shades tiles, 10mm thick (Square/rectangular) area of each tile exc. 0.18 Sqm but not exc. 0.36 Sqm, in floors etc. set and jointed in neat cement slurry and pointed in white or coloured cement to match, laid over and including 15mm thick screed bedding layerr in cement mortar 1:6 complete, all as specified. 38 Mat finish (non skid), Premium class I grade, coloured ceramic tiles, 7 to 8mm thick (Square/rectangular) area of each tile exc. 0.06 Sqm but not exc. 0.11 Sqm, in floors etc. set and jointed in neat cement slurry and pointed in white or coloured cement to match, laid over and including 15mm thick screed bedding layer in cement mortar 1:6 complete, all as specified. 39 Glazed ceramic tiles, Premium class I grade, coloured of size 300mmx600mm/450x300mm, thickness not less than 7mm as in vertical surfaces such as skirting/dado etc. set and jointed in neat cement slurry and pointed with white or coloured cement, laid over and including 10mm thick beddin layer in cement mortar 1:4 on surfaces of walls complete, all as specified. 40 M&L non skid ceramic coloured tiles of 7 to 8 mm thick (square/rectangular) area of each tile exc 0.18 sqm but n.exc 0.38 sqm on vertical surfaces such as skirtings/dado etc., set and jointed in neat cementslurry and pointed with white or coloured cement, laid over and including 10mm thick bedding layer in cement mortar 1:4 on surfaces of walls complete all as specified. 41 Chequered cement concrete tiles machine pressed heavy duty glossy tiles of size 30cm x 30cm x 25mm thick set jointed & pointed in neat cement slurry in floors with Grey cement and pigment laid over and including 15mm thick screed bed in CM 1:6, complete all as specified. 42 S&F PVC valve less, crystal white, syphonic action type flushing cistern 10 liter capacity, superior quality, plunger type, low level, with inlet, ball valve, float and handle, 32mm dia PVC long bend flush pipe 90cm long and 15mm dia 450 mm ling PVC connection with CP brass coupling nuts and PVC washers at bothy ends fixed, in repairs, all as specified. 43 S &FVitreous china wash down water closet pan (pedestal pattern), white and trap including connection to drain (or outgoing pipe) and to flushing pipe, antisyphonage pipe etc seat and cover for pedestal pan , Health faucetmild steel chromium plated suitable for 15mm dia pipe with 1.25 mtr long flexible tube and ABS wall hook including making connections and fixed in posisition complete in all respect all as specified and directed. 44 S&F in repair 15mm bore CP angle valve cast copper screwed down high pressure with crutch or butterfly handle screwed both ends for iron pipe complete all as specified. 45 Preparation of old surfaces plastered or unplastered wall surfaces including cleaning by brooming down or with steel wire brushing, scrapping down smoke spot, moulds, moss and eflllorescent salts and treating oil and greasy spots etc and applying one coat of white wash on walls, completeall as specified and directed by Engineer in charge. 46 All as per item No. 45 here-in-before but one coat of white wash on ceiling. 47 M&L for preparation of old decorated plastered or unplastered wall surfaces including cleaning by brooming down or with steel wire brushing, scrapping down smoke spot, moulds, moss and efflorescent salts and treating oil and greasy spots etc and applying one coat of distemper oil emulsion on wall all as directed by Engineer-in-Charge 48 All as per item No. 47 here-in-before but two coats of oil bound distemper on walls. 49 Preparation of old plastered wall surfaces and applying two coats of cement base paint including preparation of surfaces, complete all as specified. 50 Preparation of old painted wooden surfaces of any description and otherwise described over 10cm width or girth and applying one coat of synthetic enamel paint complete all as specified and as directed by Engineer-in-Charge. Make asian paints apcolite premium satin enamel 51 Preparation of old painted steel surfaces of any description not otherwise described over 10cm width or girth and applying one coat of synthetic enamel paint complete all as specified and as directed by Engineer-in-Charge. Asian paints apcolite rust shield 52 S&F in repair 25mm dia SS curtain rods with side SS globes and SS brackets.
