Tender For Replacement Of Passenger Lift At Drdo Transit Facility And Cce(R&D)East, Kolkata; 1 Supply, Installation, Testing, Commissioning of Passenger lift at DRDO Transit Facility and CCE(R&D)East, kolkata with undermentioned specification:Capacity: 480 Kg, Speed: 1 / 1.5 MPS, Technology: Gearless with machine Room, No of Stops: 06 Stops, 06 Levels and 06 Openings, Drive: ACVVVF / VF Regenerative (Closed Loop), Controller Type: ACD5-MRL / Micro Processor based, Control: Selective Collective, Car: Stainless Steel hairline mirror finish, Car Entrance: Stainless Steel hairline mirror finish Centre / Side Opening Power Doors, Power Supply: 400 / 415 volt, 3 phase, 50Hz, AC, Landing Doors: Stainless Steel hairline mirror finish Centre / Side Opening Power Doors, Overspeed Protection: Safety Gears & Over Speed Governors, Door lock: Car Door lock shall be provided, Lighting: LED Cabin lighting shall be provided, Alarm: Emergency Alarm system shall be provided, Automatic Emergency Rescue device: Elevator Car shall be stopped to the nearest floor and shall stay on the floor in case of power failure and open the door till the power supply is resumed, Cage False Ceiling: Aesthetic False ceiling including LED light shall be provided, Car opening panel: High quality Glass paneled door, Transparent, Poly Carbonate Material with gentle touch Led buttons shall be provided. The panels shall be made with stainless steel, Mike / Speaker: For two way communication with security personnel Mike / Speaker shall be provided, Interphone Button: Shall be provided to activate the interphone, Door opening & closing button: Door opening and closing button shall be provided to keep the door open for longer duration, Button for floor indication: Button for floor indication shall be provided to reach the floor of our choice, Service Cabinet: Service cabinet to house TI-IF accessories control with locking facility, Load weighing device: Load weighing device shall be provided, Flooring: Vinyl Tiles / Granite flooring shall be provided, Full length infra-red curtain (PANA 40): Shall be provided, Pit Depth and Overhead: Pit - 1600mm / 1500mm and Overhead 4800mm/ 5050mm , Pit Ladder and Balustrade: Shall be provided, Hand Rail: Round handrail in Stainless Steel finish provided on rear wall of car / Stainless Steel Minor Handrails on rear car panels, Entrance vertical and sill supports at all the landing: Shall be provided, Axial flow fan inside the car cabin: Shall be provided, Intercom: Intercom shall be provided, Overload Protection Buzzer: Shall be provided, Car Position indicator: Scrolling type shall be provided, Auto fan cutoff: Shall be provided, Overload device: When overload is detected the car should not start and the doors shall be opened, Emergency Car light unit: Emergency power supply will switch on upon failure of the normal lighting supply, Anti Nuisance Car call protection: Shall be provided, Nudging: Shall be provided including necessary Civil Structural Works / Electricals Works / Fabrications Works required for installations of machine.Make: OTIS / Mitsubishi/ Schindler / TK Elevator / Any other make as approved by owner. 2 Reinforced cement concrete work in beams, suspended floors, roofshaving slope up to 15° landings, balconies, shelves, chajjas, lintels, bands,plain window sills, staircases and spiral stair cases above plinth level up to floor five level, excluding the cost of centering, shuttering, finishing andreinforcement with 1 :1.5:3 (1 cement: 1.5 coarse sand(zone-111) derived from natural sources : 3 graded stone aggregate 20 mm nominal size derived from natural sources) 3 Centering and shuttering including strutting, propping etc. and removal of form for Lintels, beams, plinth beams, girders, bressumers and cantilevers 4 Brick work with common burnt clay F.P.S. (non modular) bricks of class designation 7.5 in superstructure above plinth level up to floor V level in all shapes and sizes in : Cement mortar 1 :6 (1 cement : 6 coarse sand) 5 Providing and fixing 18 mm thick gang saw cut, mirror polished, premoulded and prepolished, machine cut for kitchen platforms, vanity counters, window sills, facias and similar locations of required size, approved shade, colour and texture laid over 20 mm thick base cement mortar 1 :4 (1 cement: 4 coarse sand), joints treated with white cement, mixed with matching pigment, epoxy touch ups, including rubbing, curing, moulding and polishing of edges to give high gloss finish etc. complete at all levels. Area of slab over 0.50 sqm 6 12 mm cement plaster of mix : 1:4 (1 cement: 4 coarse sand)
