Supply, Installation, Testing And Commissioning Of 3 Nos. Ups Unit Complete With Individual Battery Set (45 Mins Backup), Of Their Batteries , Supply And Laying Of Electrical Cables And Allied Accessories In Iimc Campus , Part - A Supply,Installation,Testing & Commissioning Of The Following Ups Units(Make = Numeric / Emerson (Vertiv) / Apc / Eaton) :- , (A) 30 Kva Ups Area/ Location: Cam Centre , (B) 20 Kva Ups Area/ Location: A Block , (C) 20 Kva Ups Area/ Location: B Block , Note:-Ups Warranty = 2 Years From Date Of Successful Installation (For Technical Details Refer - Technical Data Sheet). , (Less) Buy Back Of Following Ups , (A) 30 Kva Ups Area/ Location: Cam Centre , (B) 20 Kva Ups Area/ Location: A Block , (C) 20 Kva Ups Area/ Location: B Block , Supply & Installation Of Following Smf Type Battery Bank (Make - Exide) For Minimum 45 Minutes Back Up Along With Battery Stand. The Batteries Shall Have A 2 Years Warranty From Date Of Installation. Job Includes Net Cost After Buyback Of Old Batteries :- , (A) Full Set Battery For 25 Kva Ups Area/ Location: Cam Centre , (B) Full Set Battery For 20 Kva Ups Area/ Location: A Block , (C) Full Set Battery For 20 Kva Ups Area/ Location: B Block , Supply & Laying Of Interconnecting Cables (Battery To Battery Connection), Cable From Ups To Battery Bank. , Part - B (Electrical Work) , Supply Of 3.5 C X 35 Sq. Mm Al Armoredcable From Ntb Ups Room To Tagore Common Room. (Make: Polycab/Kei/Havells). , Supply Of 3.5 C X95 Sq. Mm Al Armoredcable From Ntb Power Feeder To Ntb Ups Feeder. (Make: Polycab/Kei/Havells). , Laying Of The Above 3.5 Cx 35 Sq. Mm Al Cable In Direct Burial In Ground With Proper Brick Protection As Per Ie Rule. Cpwd.-P-26,7.1.1 , Laying Of The Above 3.5 Cx 95 Sq. Mm Al Cable In Direct Burial In Ground With Proper Brick Protection As Per Ie Rule. Cpwd -P-26,7.1.2 , Supply And Fixing Of 63 A Tpn Mcb With Metal Enclosure,40 A Dp C/O And Cable End Box With 2 X 4 Sq Mm Copper Wire, Pipe With Wiring. (Make: Havells/L&T/Standard). , Preparation Of 35 Sq. Mm Gland With Lugs End Termination And Connection Complete. Cpwd.-P-29,9.1.21 , Preparation Of 95 Sq. Mm Gland With Lugs End Termination And Connection Complete. Cpwd.-P-29,9.1.24 , Road Borrowing For The Armored Cable Protection. , Supply Of 2 Inch Dia Gi Pipe For The Cable Protection. (Make : Tata Medium/Jindal). , Supply , Installation, Testing & Commissioning Of Weather Proof Out Door Type Feeder Pillar Aluminum Painted Made Of 12 Swg Ms Sheet Double Hinged Biparting Door At Front And Back Side Feeder Box At Ntb Building For Ups Line. The Feeder Pillar With Dimension (Height-1350Mmxw-1000 Mm X D-600Mm ) Should Consist Of The Folling:- A)320 A Porcelain Fuse -3 Nos B) 200 A Porcelain Fuse-12Nos C) 300 A Copper Bus Bar-4 Nos D)20 Mm Thick Bakelite Sheet-1 No In Adequate Size E) Fabrication And Painting-1 Job F) Iron Angle Frame G) Danger Plate Etc. , Installation Of Above Feeder Box With Proper Brick Foundationand Completely Cement Plasteringand Also Concreteof The Proper Ratio Of Sand, Cement & Stonefor Iron Angle Frame. , Preparation Of Feeder Pillar Platform For The Electrical Maintenance , Preparation Of Earthing With G.I. Earth Pipe 4.5 Metre Long, 40 Mm Dia Including Accessories, And Providing Masonry Enclosure With Cover Plate Having Locking Arrangement And Watering Pipe Etc. With Charcoal/ Salt As Per Required. As Per I.E Rule. Cpwd. P-23,Code-5.1 , Supply And Laying 25 X 5 Mm Gi Strip For The Earthing Connectivity From Feeder Box To Earthing Pipe With Proper Nut Bolt Etc. P-23, Code-5.9 , Dismantling The Old Feeder Box In Respect Of New Proposed Feeder Box With Allied Electrical Work I.E. Existing Cable Dismantling And Preparation Of Proper Gland Socketing In The New Feeder Box. , Old Existing Feeder Shifting At Go-Down. , Any Miscellaneous Work Not Covered In Present Schedule But Is Required To Be Done On A As And When Basis Will Be Executed By The Contractor. Work Value Will Be Ascertained Based On Rate Analysis / Original Bill Submission. 10% Profit Will Be Paid On Original Bil Value Submitted. The Work Will Be Done As Per Direction Of Engineer- In- Charge.
