|
| 1 | Excavation for StructuresEarth work in excavation of foundation of structures as per drawing and technical specification,including setting out, removing, spreading or stacking of spoils within a lead of 150 m. as directed and including trimming the sides of the trenches, leveling, dressing and ramming the bottom, and backfilling with approved material complete as per direction of the Engineer-in-Charge. a) upto 3 m depth(i) With pumping andout watershoring |
| 2 | Labour for laying 150 mm to 200 mm boulder soling including rough dressing hand packing and ramming down small pieces in the interstics including rolling and preparing the bed to proper level and filling up all joints with sandy clay or earth. |
| 3 | Providing and laying Design Mix concrete for plain / reinforced concrete work in any part of bridge (excluding bottom plugging) with coarse aggregates of appropriate nominal size and grading, fine aggregate (sand) conforming to proper grading zone, both of approved quality and cement, as necessary, including labour, cost and carriage of all materials and including preparation of design mix, approval of the same by the Engineer-in-Charge and cost for quality control, sampling, testing etc. all complete but excluding cost of labour and materials for formwork & reinforcement works. (a) M-15 Grade Using concrete mixer. |
| 4 | Supplying fitting and placing HYSD bar reinforcement in bridge super-structure including initial straightening, straightening of coils bars removal of loose rust(if any) , cutting to requsite length bending, binding with annealed wire not less than 1 mm in size and conformong to IS 280 at every intersection hooked and bent to correct shape and placed on forms etc. including cost of black annealed wire and cost of loading , unloading, carriage of all steel materials complete as per drawing and technical specifications.(i) a. MIID STEEL ROADS ( Others than SAIL/TATA/RINL)( DETAIL TO BE IN BILL) |
| 5 | Providing and laying Design Mix concrete for Plain / Reinforced Cement Concrete in any part of foundation of bridge /culvert with graded stone chips of appropriate nominal sizes , including screening and cleaning of coarse aggregates, fine aggregate (sand}B} RCC grade M 20 with 22.40 mm Size |
| 6 | Hire and labour charges for Shuttering with or without staging upto 4.0 m height using approved stout props with wooden planks/ ply board/ steel sheet platewith required bracing for any kind of plain or reinforced concrete worksin all sorts of minor structure including culvert, box culvert, cross-drain etc. the rate is inclusive of fitting, fixing and striking out after completion of work as per specification and direction.ii) Where staging is not required. |
| 7 | Plaster (to wall, floor, ceiling etc.) with sand and cement mortar including rounding off or chamfering corners as directed and raking out joints including throating, nosing and drip course, scaffolding/staging where necessary (Ground floor).[Excluding cost of chipping over concrete surface] (ii) With 1:4 cement mortar (b) 15 mm thick plaster |
| 8 | Providing & fixing concrete sign board as per IRC specification of size 900x750x37 mm thick made with RCC 1:1.5:3 with pakur variety stone chips reinforcement with double layer IRC febric ( 75 mm x 75 mm mesh ) and fixed with necessary nuts & bolts on two RC precast posts 100 mm x 15o mm of height 2.65 m of which top 750 mm is of section 100 x 13 and 1.90 m above GL & .75 m below G.L including digging hole repacking the same with cement concrete 1:3:6 with jhama khoa with local stone chips etc complete including painting two coats on both faces lettering sign marks etc as per direction of the Engineer in charge . ( Rate is inclussive of cost of reinforcement concrete shuttering nuts & bolts washer etc comlete |
| 9 | ADD GST @18% |
| 10 | ADD LABOURCESS 1% |
