Bids Are Invited For 1 Clearing Jungle Including Of Uprooting Of Rank Vegetation, Grass, Brush, Wood, Tree And Sapling Of Girth Up To 30 Cm Measured At A Height Of 1 M Above Ground Level And Removal Of Rubbish Outside The Periphery Of The Area Cleared 2, Ballari-Karnataka

Bids Are Invited For 1 Clearing jungle including of uprooting of rank vegetation, grass, brush, wood, tree and sapling of girth up to 30 CM measured at a height of 1 m above ground level and removal of rubbish outside the periphery of the area cleared 2 Provision for earthwork excavation in hard soil for laying granite stone flooring/apron by using granite stone slabs of size 0.90 to 1.20m of length, 0.45 to 0.60m of width, 0.10m thickness and laying brick jelly concrete bed of 0.10m thick in lime mortar 1into2, providing pointing to the joins in lime mortar 1into2, etc. including excavation work, laying concrete bed, laying stone flooring, pointing, cutting, dressing, lifting, carrying, cost of all materials, labour charges, curing, etc. complete all as per the specifications and directions of site-in charge. 3 Polishing in high gloss/matt finish melamine clear polish on wood work in required colour/wooden shade texture with following process in the sequence as detailed below 1.The surface to be polished is rubbed with sand paper 80/120 no. and then with sand paper of 160/180 nos. 2. Applying two coats of sealer with spray gun and allowing sufficient drying time for 1st coat and 2nd coat is allowed to dry for 8 to 12 hrs. 3. On drying of sealer coat, wet rubbing with emery cloth of finer grading with ample water to remove excess sealer layer and make the surface further smooth after this wet rubbing, then surface is applied with special grade melamine fillers to fill all the small and big holes/grooves etc. Filler coat to be allowed to dry for 4 to 6 hrs on which again a light wet rubbing is done this surface is further allowed to dry for 12 hrs. 4. On this, 1st coat of melamine polish is applied with spray gun using melamine clear polish and melamine thinner in required proportion. This 1st coat is allowed to dry for 24 hrs then this dry surface is again fine wet rubbed smooth, which is further allowed to dry for 12 hrs. The final melamine polish is applied with compressor pressure spray gun using melamine clear polish and melamine thinner mixed in required proportion complete as per direction of Engineer- in Charge 4 1 5 1 Total Quantity : 8129

Refer document

INR 40900.0 /-

INR 16.32 Lakhs /-