Tender For Tga-Dta-Dsc, berhampur-Odisha

Tender For Tga-Dta-Dsc; 1. 1Operating temperature range: Room Temperature to 1000°C and higher 2. 2Temp. Accuracy: ± 1°C or better 3. 3Temp. Precision: ± 0.5K or better 4. 4 Isothermal Temperature Precision: ± 0.1°C 5. 5Linear Heating Rates: 0.1 to 100°C/min in 0.01°C/min increments. 6. 6Heating rate: 0.02 - 100K/min. or 0.02 - 250K/min. (Ballistic) or better 7. 7Cooling time: 20 mins (1000 °C to 100 °C) or better 8. 8Furnace design:  Horizontal/Vertical to give stable weight signal with automatic opening/closing of the furnace and easy sample loading.  Either a wire-wound, low mass ceramic furnace or a quartz- lined evolved gas analysis furnace. The wire-wound furnace comes as a standard part. 9. 9Balance capacity: 1 gm 10. 1 0 Weighing accuracy: 0.01% or better 11. 1 1 Weighing precision: 0.01% or better 12. 1 .Balance Repeatability: ˂0.001 mg or better 13. .Typical Minimum Weight: 0.20 mg or better 14. 1 4 . Micro Balance:  Micro Balance weight change measurements should not be dependent on sample positioning (Parallel Guided Balance/ Horizontal/ Vertical). Thermo-stated and electrically heated balance housing has an auto-calibration facility with built-in weights.  The balance should have the facility for external calibration with Certified weights.  The system does not require a change of Tare pan while changing Crucibles. Should not be Tare pan- dependent calibration  As a safety pre-requisite, the Balance was continuously purged with Protective Gas (N2) 15. 1 .Calibration of Balance: Have fully Automatic Calibration capability with built-in calibration weights. Facility to use certified external weights 16. 1 6 . Balance protection: Thermostated Water is cooled to minimize environmental influence and rapidly cool the furnace as well as protective inert gas to protect the balance from undesired decomposition gases/products.

Refer document

INR 200000.0 /-

INR 95 Lakhs /-