Name Of The Work : Inside Repairing Of Block-M( Flat No-2,Metrological Office) At Anasua Housing Estate., Medinipur-West Bengal

Name Of The Work : Inside Repairing Of Block-M( Flat No-2,Metrological Office) At Anasua Housing Estate.-1 Stripping off worn out plaster and raking out joints of walls, celings etc. up to any height inside & out side walls including scaffolding, removing rubbish and stacking within 75 mtr. Distance all complete as directed. 2 Plaster (to wall, floor, ceiling etc.) with sand and cement mortar including rounding off or chamfering corners as directed and raking out joints including throating, nosing and drip course, scaffolding/staging where necessary (Ground floor). [Excluding cost of chipping over concrete surface] (ii) With 1:4 cement mortar (b) 15 mm thick plaster Ref:- Derrived rate 3 Taking out shutter of door and window, dismantling by parts (for repair or replacement of damaged parts) , reassembling and refitting and rehanging same with old fittings but with new screws as necessary. (Where different parts of same shutter are renewed under different item, payment under item 73 will be made once only). 4 Panel shutters of door and window, as per design (each panel consisting of single plank without joint), including fitting and fixing the same in position but excluding the cost of hinge and other fittings. In ground floor. (In case of non-supply of single plank, penal rate of reduction of 20% will be made)(iii) 35mm thick shutters with 19mm thick panel of size 30 to 45 cm. b) Sishu, Gamar, Champ,Badam,Bhola, Mogra, Hallak. 5 Wood work in door and window frame fitted and fixed in position complete including a protective coat of painting at the contact surface of the frame exluding cost of concrete, Iron Butt Hinges and M.S clamps. (The quantum should be correted upto three decimals). (d) Sal : Local. 6 Iron butt hinges of approved quality fitted and fixed with steel screws, with ISI mark.(iii) 75mm. X 40mm. X 1.12mm. 7 (b)Priming one coat on timber or plastered surface with synthetic oil bound primer of aooroved quality including smoothening surfaces by sand papering etc. b) 8 A) Painting with best quality synthetic enamel paint of approved make and brand including smoothening surface sand papering etc. including using of approved putty etc. on the surface, if necessary : a) On timber or plastered surface : iv) Two coats (with any shade except white) 9 (b) Priming one coat on steel or other metal surface with synthetic oil bound primer of approved quality including smoothening surfaces by sand papering etc.6 Iron butt hinges of approved quality fitted and fixed with steel screws, with ISI mark.(iii) 75mm. X 40mm. X 1.12mm. 7 (b)Priming one coat on timber or plastered surface with synthetic oil bound primer of aooroved quality including smoothening surfaces by sand papering etc. b) 8 A) Painting with best quality synthetic enamel paint of approved make and brand including smoothening surface sand papering etc. including using of approved putty etc. on the surface, if necessary : a) On timber or plastered surface : iv) Two coats (with any shade except white) 9 (b) Priming one coat on steel or other metal surface with synthetic oil bound primer of approved quality including smoothening surfaces by sand papering etc.

Refer document

Refer document

INR 57174.0 /-