Supply of Snow marker pole made up of MS round hollow pipe of dia 65 MM and 3.65 MM thick. The total length of pole should be 4500 MM from base plate. One No of equal angle iron of size 40 MM x 40 MM x 6 MM thick of length 662 MM will be attached by the nut and bolts at top of the pole as horizontal member. One No of Angle iron of size 40 MM x 40 MM x 6 MM thick of length 900 MM will be used as strut to strengthen to horizontal member by the nut and bolts. Radium marking should be done on every feet of the pole, three different colour of radium tape will be done on top of the pole. All works should be done as per drawing and Technical Sanction attached with costed schedule of work.
2
Steel cable of gauge 3 MM
Steel cable of gauge 3 MM
3
Protective Helix
Protective Helix (Design as per the photograph attached with costed schedule work and sample as approved by user)
4
Aluminium Suspension helix.
Aluminium Suspension helix. (Design as per the photograph attached with costed schedule work and sample as approved by user)
5
Terminating Helix
Terminating Helix. (Design as per the photograph attached with costed schedule of work and sample as approved by user)
6
Thimble
Thimble. (Design as per the photograph attached with costed schedule of work and sample as approved by user)
7
Turn Buckle
Turn Buckle. (Design as per the photograph attached with costed schedule of work and sample as approved by user)
8
D-Shackle
D - Shackle. (Design as per sample as approved by user)
9
Clamp circular
Clamp circular. (Design as per the photograph attached with costed schedule of work and sample as approved by user)
10
Ordinary Portland Cement OPC
Ordinary Portland Cement(OPC) grade 43 confirming to IS 1489 Make - Ambuja/ACC/Ultratech
11
Coarse sand
Coarse sand, sand shall be clean, sharp, angular free from adherend coaling and shall not contain clay, mica and other impurities. The maximum quantities of clay and fine sand shall not be more than 5% by mass as per IS-383-1970 and grade shall comply with Zone II to zone III.
12
Stone aggregate
Stone aggregate shall be crushed stone 20mm graded conforming to IS-383-1970 and shall be clean hard tough, durable and uniform quality throughout. The aggregate shall be free from soft disintegrated material, vegetable and other organic impurities.
We takes all possible care for accurate & authentic tender information, however Users
are requested to refer Original source of Tender Notice / Tender Document published by
Tender Issuing Agency before taking any call regarding this tender.
