Bids Are Invited For Nomenclature Drawing No. Specifications Charpoy Ip With Hard Top Fd / Map-Ii / 01 1 ) Over All Size 1980X900x400 Mm. Frame Shall Be Of Ms Rectangular Pipe Of Size 25X65 Mm As Shown On Drg Having Wall Thickness Of 16 Guage.Legs , TIRUVALLUR-Tamil Nadu

Bids Are Invited For Nomenclature Drawing No. Specifications Charpoy Ip With Hard Top Fd / Map-Ii / 01 1 ) Over All Size 1980X900x400 Mm. Frame Shall Be Of Ms Rectangular Pipe Of Size 25X65 Mm As Shown On Drg Having Wall Thickness Of 16 Guage.Legs Shall Be Of Ms Sq Pipe Of Size 32X32mm Having Wall Thickness Of 16 Guage. 2 ) Two Equal Siffners Of Ms Sq Pipe Of Size 25X25mmx16 Guage Shall Be Used. Six Nos Ms Cleat Of Size 25X60x6mm Shall Be Welded With Frame To Support Ply As Shown On Drg. 3 ) Top Of Bed Shall Be Of 12Mm Thick Plywood , 7 Ply, Grade Bwr Type Aa As Per Is-303 / 1989. Screwed With Ms Cleat & Stiffners With Cup & Washer. 4 ) All Ms Surfaces After Fabrication Shall Be Thoroughly Cleaned & Given A Phosphate Treatment Conforming To Is-1477 ( Part-I ) & Finished With Epoxy Polyester Coating Of Black Colour Of Indigenous Make Conforming To Is-13871.The Thickness Of Coating Shall Be Not Less Than 70 Micron ( 7 Tank Process ) & Oven Dried With Following Specifications: ( A ) Dry Film Thickness More Than 45 Microns ( B ) Salt Spray Test To With Stand More Than 1000 Hours. ( C ) Adhesion As Per Din 53152 Standards. ( D ) Pencil Scratch Hardness More Than 2H. Chair Cb ‘A’ Special With Hand Rest Fd-120 ( M ) ( R ) ( I ) All As Shown On Drawing. Legs And Frame Shall Be Of 19 Mm Square Mild Steel Tube Of Wall Thickness 1.6 Mm. Wood Shall Be Of First Class Hard Wood Teak.Wood For Seat & Back Of Chair Shall Be Of Teak Wood. Cane For Seat And Back Shall Be 0.4Mm Thick & 2 Mm Wide Except Border Which Shall Be 3 / 4Mm Wide And Weaving Shall Be Done In Godrej Pattern.20 Mm Thick Teak Wood Plank In One Piece Shall Be Provided On Right Hand Side & Shall Be Fixed As Shown On Drg. ( Ii ) All Steel And Iron Surfaces Shall Be Painted With Two Coats Of Synthetic Enamel Paint ( Shade As Approved By Ge ) Over A Coat Of Primer After Preparation Of Surfaces. ( Iii ) All Wood Surfaces Shall Be French Polished With High Gloss Finish. ( Iv ) Hard Rubber Or Pvc Shoes Shall Be Provided At The Bottom Of Legs. ( V ) All Joints, Fixing Shall Be Done In Accordance With Standard Workmanship And Specifications.

Refer document

INR 144000.0 /-

INR 48 Lakhs /-