Tender For Rod Repair Outside Plant-Multi State

Tender For Rod Repair Outside Plant -Operations -1. Loading of rejected rods from various locations of Rodding shop 2. Supply of hiwa, hydra and workers 3. Loading of MS Brackets and Aluminum rods 4. Minimum 2 hiwa and maximum 4 hiwa required to lift the rejected rods depend on the availability of rejected rods. 5. At any point of time, all 4 hiwa should be ready at contractor side. 6. New generation hydra required for loading and unloading of rods inside plant. 7. Rejected rods will be load in presence of Balco security and Balco employee of Rodding shop. 8. Empty jumbo bag and empty container will be loaded along with rejected rods 9. RGP will be made after loading of all material and final weighment. 10. Trip will be close based on RGP weighment. 11. Any noncompliance in SOP will result in heavy penalty which leads to termination of contract. 12. All damage cut round bar and turning chips will come back along with repair rods. 13. Cutting and welding babries (burn MS of round bar) will not allowed along with repair rods, this will be not considered in final weighment. 14. Repairing and replacement of MS bush of rod will be under the contractor scope. 15. MS bush specification will be provided by Balco. 16. Supply of Trimetallic clad and round bar is in Balco scope. 17. New clad will go outside with RGP and RGP will be close after receiving damage clads. 18. All hiwa and hydra should have valid safety parameters as per Balco norms and If found any noncompliance in any vehicle then penalty will be imposed to contractor as per Balco rules. 19. Tested and standard Chain sling will be required for loading and unloading of rods, which is under the contractor scope. 20. Tested and standard ladder will be required for climb of hiwa, which is under the contractor scope. 21. Standard rope (Polyamide/ceramide) dia-18/25mm will be required for tightening of rods. 22. Payment will be done as per given line item in PO. 23. Daily basis MIS will be required against each RGP with weighment slip proof. 24. Bank Guarantee will be required for 180 rods. 25. Contractor has sufficient numbers of machines such as bend saw, lathe, welding machine, crane or hydra, DG Set etc. should be available at workshop so that he can repair 90 to 120 rods as per requirement at plant. 26. DP test will be done in all aluminum repair rods on daily basis. 27. All DP test material will be under the contractor scope. providing new Clad , repairing old Clad ,Damaged Rods ,Cutting and Welding of Bracket pin

Refer document

Refer document

Refer document