Quotation Are Invited For Pneumatic Mp Positioner

Quotation are invited for Pneumatic Mp Positioner Delivery Date: 2025/04/30 Delivery To: Blackheath WTP Blackheath WTP Delivery Address: 0000 Blackheath WTP, CAPE TOWN Closing Date: 2025/02/11 Closing Time: 12:00 PM Description: 5 each x pneumatic mp positioner Specification: * QUOTATION CONDITIONS CLAUSE - 2.14.1 & 2.15 Provide, on request by the CCT, any other material that has a bearing on the quotation offer, the supplier#s commercial position (including joint venture agreements), preferencing arrangements, or samples of materials, considered necessary by the CCT for the purpose of the evaluation of the quotation. If the Specifications require the supplier to provide samples/technical data sheets, these shall be provided strictly in accordance with the instructions set out in the Specification. If such samples /technical data sheets are not submitted as required in the bid documents or within any further time stipulated by the CCT in writing, then the bid concerned may be declared non-responsive. # Wherever reference is made to any particular Trade Mark, Name, Patent, Design, Type, Specific Origin or Producer, such reference shall be deemed to be accompanied by the words or equivalent # NB: The Municipal Bidding Document 6.1 (MBD 6.1) is attached, in order to be eligible for preference points bidders are required to submit a duly completed, current dated MBD 6.1 document with supporting documents with each and every RFQ submission, failure to submit will result in zero point allocation. The MP Positioner is designed to drive a rotary or linear actuator to a position set by a 3-15 psi (0.2 to 1.0 bar) signal and hold it there until the signal changes. When a signal pressure is applied to the diaphragm it moves the force balance lever clockwise against the tension of the feedback spring. This moves the spool valve, supplying air pressure to one side of the actuator while exhausting trapped air from the other side. The feedback shaft follows the movement of the actuator and turns the cam counter clockwise, pushing the cam follower and increasing the tension on the feedback spring until it balances the forces on the diaphragm and moves the spool valve to its hold position. The input signal and desired position is determined by the cam profile. A cam giving 0-90° output movement linearly proportional to a 3-15 psi (0.2-1.0 bar) signal must be standard. The AP POSITIONER MUST BE COMPATIBLE WITH THE KINETROL MODEL 144-100 DOUBLE ACTING PNEUMATIC VANE ACTUATOR WITH A SHAFT 07 SQUARE. Tender Link : http://web1.capetown.gov.za/web1/ProcurementPortal/RFQ/Details/300453

Refer document

FileName	File Description
Global Tender Document	Tender Notice