Bids Are Invited For The Object Of This Bidding Consists Of The Acquisition Of Agricultural Equipment, Including: 01 Pivot Draging Planter, 01 Plow Hill, 01 Subsoling Plow, 01 Dry Fertilizer Distributor And 02 Mixing Wagon (Desiler) For Strengthening And Developing Secret Programs Municipal Aria Of Agriculture And Environment Along The Municipality’S Rural Properties.
Bids Are Invited For The Object Of This Bidding Consists Of The Acquisition Of Agricultural Equipment, Including: 01 Pivot Draging Planter, 01 Plow Hill, 01 Subsoling Plow, 01 Dry Fertilizer Distributor And 02 Mixing Wagon (Desiler) For Strengthening And Developing Secret Programs Municipal Aria Of Agriculture And Environment Along The Municipality’S Rural Properties.
Subsoiler Plow With At Least 1.6M Wide, Required Power 40 Hp, 5 Rods, Plow Harrow With Remote Control With At Least 14 Concave Discs Separated By Pads And Fixed By Double Bearing Bearings With Easily Accessible Oil Or Grease Lubrication Point , Discs Size 26 Inches With At Least 4 Lines Double Discs For Fertilizer, Side Tires 12 Plies Polythylene Fertilizer Reservoir With Capacity For 620L Fertysystem System Equipment Weight 1,300 Kg, Dry Fertilizer Distributor, Equipment Attachable To Agricultural Tractor, New, Fertilizer Distributor Type And Seed Seeds, With The Following Minimum Characteristics: With A Maximum Width Of 22 Meters In Scope, Having A Manual Drive System Through Levers With Easy Access To The Driver Located Just After The Fitting On The Third Point Of The Tractor, Stainless Steel Distribution Monodisc, With Adjustable Paddles To Guarantee Uniformity, Throughout The Application Range, With Capacity Of 400 Liters And Reservoir All Molded In Polyethylene With Protection Against Ultraviolet Rays, Power Required At Power Take-Off 50 Hp, Rotation 540 Rpm, Tractioned Mixing Wagon With Capacity For 1 , 5M³, With Stainless Steel Mixing Tank, Equipped With Mixing Screw, Tank With Counter Knife, Desilting Arm With Desilting Drum With Independently Replaceable Crossed Knife System, Milling Cutter With Pressure Sensor, Discharge Screw Assembly With Bearing And Removable Thread, Cutting Milling Cutter With Dynamic Balancing, Ball Joint And Self-Aligning Bearing For Self-Aligning The Cutter Shaft, Armored Oil Tank, Resistance For Mixing Long Fiber And Silage In General, Rear Protection Of The Desilation Roller, Cardan Protection, Thread For Direct Discharge Into The Trough. Transmission Through An Oil-Bathed Gearbox And Chains Fully Sized To Withstand Efforts, Desensitizer Drive Via A Hydraulic Pump And Piston Joint, Rotation Required At A Tdp Of 540 Rpm And Power Required From 50 Hp At A Tdp.
We takes all possible care for accurate & authentic tender information, however Users are requested to refer Original source of Tender Notice / Tender Document published by Tender Issuing Agency before taking any call regarding this tender.
